The patch
ASoC: fsl_ssi: Fix number of words per frame for I2S-slave mode
has been applied to the asoc tree at
git://git.kernel.org/pub/scm/linux/kernel/git/broonie/sound.git
All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted.
You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed.
If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced.
Please add any relevant lists and maintainers to the CCs when replying to this mail.
Thanks, Mark
From 4f14f5c11db161ab89b02f7196496ca32ca5dbf8 Mon Sep 17 00:00:00 2001
From: Alexander Shiyan shc_work@mail.ru Date: Sat, 25 Jun 2016 07:59:22 +0300 Subject: [PATCH] ASoC: fsl_ssi: Fix number of words per frame for I2S-slave mode
The i.MX51 datasheet says: Chapter 56.1.2.4 I2S Mode ... When I2S modes are entered (I2S master (01) or I2S slave (10)), the following settings are recommended: ... - TX Frame Rate should be 2 i.e. (STCCR[12:8] = 1) - RX Frame Rate should be 2 i.e. (SRCCR[12:8] = 1)
Chapter 56.3.3.12 SSI Transmit and Receive Clock Control Registers (STCCR & SRCCR) ... Bits 12-8 DC4-DC0 Frame Rate Divider Control. These bits are used to control the divide ratio for the programmable frame rate dividers. The divide ratio works on the word clock. In Normal mode, this ratio determines the word transfer rate. In Network mode, this ratio sets the number of words per frame. The divide ratio ranges from 1 to 32 in Normal mode and from 2 to 32 in Network mode. In Normal mode, a divide ratio of 1 (DC=00000) provides continuous periodic data word transfer. A bit-length frame sync must be used in this case.
Function fsl_ssi_hw_params() setup Normal mode for MONO output, so with DC=0, SSI enters to continuous periodic data word transfer. To fix this, setup DC for any I2S mode. Patch has tested on custom board based on Digi CCMX-51 module (i.MX51).
Signed-off-by: Alexander Shiyan shc_work@mail.ru Signed-off-by: Mark Brown broonie@kernel.org --- sound/soc/fsl/fsl_ssi.c | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-)
diff --git a/sound/soc/fsl/fsl_ssi.c b/sound/soc/fsl/fsl_ssi.c index 632ecc0e3956..bedec4a32581 100644 --- a/sound/soc/fsl/fsl_ssi.c +++ b/sound/soc/fsl/fsl_ssi.c @@ -952,16 +952,16 @@ static int _fsl_ssi_set_dai_fmt(struct device *dev, ssi_private->i2s_mode = CCSR_SSI_SCR_NET; switch (fmt & SND_SOC_DAIFMT_FORMAT_MASK) { case SND_SOC_DAIFMT_I2S: + regmap_update_bits(regs, CCSR_SSI_STCCR, + CCSR_SSI_SxCCR_DC_MASK, + CCSR_SSI_SxCCR_DC(2)); + regmap_update_bits(regs, CCSR_SSI_SRCCR, + CCSR_SSI_SxCCR_DC_MASK, + CCSR_SSI_SxCCR_DC(2)); switch (fmt & SND_SOC_DAIFMT_MASTER_MASK) { case SND_SOC_DAIFMT_CBM_CFS: case SND_SOC_DAIFMT_CBS_CFS: ssi_private->i2s_mode |= CCSR_SSI_SCR_I2S_MODE_MASTER; - regmap_update_bits(regs, CCSR_SSI_STCCR, - CCSR_SSI_SxCCR_DC_MASK, - CCSR_SSI_SxCCR_DC(2)); - regmap_update_bits(regs, CCSR_SSI_SRCCR, - CCSR_SSI_SxCCR_DC_MASK, - CCSR_SSI_SxCCR_DC(2)); break; case SND_SOC_DAIFMT_CBM_CFM: ssi_private->i2s_mode |= CCSR_SSI_SCR_I2S_MODE_SLAVE;