On 11/04/2014 02:11 PM, David Henningsson wrote:
On 2014-11-03 23:58, Chris J Arges wrote:
This code contains the Scarlett mixer interface code that was originally written by Tobias Hoffman and Robin Gareus. Because the device doesn't properly implement UAC2 this code adds a mixer quirk for the device.
Thanks a lot for taking over - it surely has been done with better speed than I would have.
- Code cleanup:
- David Henningsson <david.henningsson at canonical.com>
Thanks for the credit, not sure I deserve it though, all I did was to squash the patches and fix the checkpatch errors :-)
: )
+static int scarlett_ctl_save_put(struct snd_kcontrol *kctl,
struct snd_ctl_elem_value *ucontrol)+{
- struct usb_mixer_elem_info *elem = kctl->private_data;
- struct snd_usb_audio *chip = elem->mixer->chip;
- char buf[] = { 0x00, 0xa5 };
- int err;
- if (ucontrol->value.enumerated.item[0] > 0) {
err = snd_usb_ctl_msg(chip->dev,usb_sndctrlpipe(chip->dev, 0), UAC2_CS_MEM,USB_RECIP_INTERFACE | USB_TYPE_CLASS |USB_DIR_OUT, 0x005a, snd_usb_ctrl_intf(chip) |(0x3c << 8), buf, 2);if (err < 0)return err;usb_audio_info(elem->mixer->chip,"scarlett: saved settings to hardware.\n");- }
- return 0;
+}
To elaborate on Takashi's concern about this control, imagine e g what alsactl restore/store being run on startup/shutdown. On shutdown, alsactl store would read "0", and on startup, alsactl restore would write "0", with the result that the hw would not store the values set.
Would it be possible to have an autosave instead? E g, whenever a value is changed, it saves that value to the hardware. That's how other hardware works and what userspace expects. If you want to avoid a lot of autosaves, e g if the autosave takes a lot of time before the hw responds, maybe you could do the autosave in a 10 ms delayed_work, or similar.
David, Hey, as Tobias mentioned this is a HW saving (to the mixer's NVRAM) function used for using the mixer disconnected from a computer. We wouldn't want to continually write the NVRAM on every control update as I'm unsure of how many write-cycles the device is capable of.
So without it you can still plug the mixer into the computer and alsa will restore any saved settings automatically. I'm planning on dropping the HW Save in v5 until we can figure out a proper control mechanism for this.
--chris