Dne 28. 07. 20 v 20:54 Pavel Hofman napsal(a):
Dne 28. 07. 20 v 20:04 Pavel Hofman napsal(a):
Dne 28. 07. 20 v 19:04 Takashi Iwai napsal(a):
Would adding atomic_add(&meter->reset, 1) in snd_pcm_meter_reset() help?
Unfortunately not.
s16_reset is called correctly, setting s16->old = meter->now; But at that time meter->now is still 22751, setting s16->old to the same value.
s16_update 1: meter->now 22751, s16->old 22751, size 0
However, in the next update call meter->now comes from the freshly started application pointer:
s16_update 1: meter->now 839, s16->old 22751, size -21912
Of course this helps:
- if (size < 0) - size += spcm->boundary; + if (size < 0) { + size = meter->now; + s16->old = 0; + }
But I understand this is not a solution because:
- it will not work at reaching spcm->boundary (after thousands of hours?)
- it will cause the same problem when the stream is rewound (which is
the problem now too) - size will equal to large meter->now (length from the beginning of the stream minus the rewound = large number).
IMHO there are two cases of the [application pointer + delay] drop compared to the previous run:
- stream start, rewinding => s16->old = meter->now; size =0, i.e.
skipping the samples to show
- wrapping at spcm->boundary => size += spcm->boundary, i.e. showing the
wrapped samples
Optionally the second case could be handled just like the first case by resetting s16->old, assuming the boundary wrap occurs very infrequently.
The following patch is tested to work OK, no CPU peaks and no meter output glitches when the size < 0 condition occurs:
diff --git a/src/pcm/pcm_meter.c b/src/pcm/pcm_meter.c index 20b41876..48df5945 100644 --- a/src/pcm/pcm_meter.c +++ b/src/pcm/pcm_meter.c @@ -1098,8 +1098,15 @@ static void s16_update(snd_pcm_scope_t *scope) snd_pcm_sframes_t size; snd_pcm_uframes_t offset; size = meter->now - s16->old; - if (size < 0) - size += spcm->boundary; + if (size < 0) { + /** + * Application pointer adjusted for delay (meter->now) has dropped compared + * to the previous update cycle. Either spcm->boundary wraparound, pcm rewinding, + * or pcm restart without s16->old properly reset. + * In any case the safest solution is skipping this conversion cycle. + */ + size = 0; + } offset = s16->old % meter->buf_size; while (size > 0) { snd_pcm_uframes_t frames = size;
Please will you accept this (workaround) bugfix? If so, I would send a proper patch.
Thanks a lot,
Pavel.