On Sat 2018-03-31 16:43:14, Tony Lindgren wrote:
- Pavel Machek pavel@ucw.cz [180331 19:56]:
On Sat 2018-03-31 21:46:16, Pavel Machek wrote:
On Sat 2018-03-31 21:19:39, Pavel Machek wrote:
On Sat 2018-03-31 11:19:35, Tony Lindgren wrote:
Cool :) Microphone still does not work for me.. I tried tweaking the alsamixer settings but no mic. This is with cold boot with droid4-kexecboot if that might make a difference, we may have some register uninitialized somewhere. Any ideas?
Ok, I was focusing on the speaker side.
alsamixer, tab to go to capture settings, set it to 37 37 Mic2 Mic1 should work, according to my notes, but not recently tested and not tested against real human.
I'll attempt to test it, but something in my userland shuts down system just after boot 60% of time, which is rather annoying.
Hmm. So I tried again, and setting Mic1 and back in the capture settings crashed the modem. Bang, disconnected from the USB.
Next try, and it worked this time.
_Before the call_, set mode to Normal and then Call. Then go to capture, and set 100 100 Mic2 Mic1. Then place a call,
AT+CFUN=1 OK ATD6;
No luck with microphone here :( Using ttyUSB4, AT+CFUN=1 works, but ATD command on it just hangs the USB interface and I have to reload phy-mapphone-mdm6600 to reset the modem.
Test call with real human worked (thanks to Rolf K.), I could hear him well but he reported call was very quiet. And that was with capture settings at 100%.
If you had a register dump from android with mics working, preferably not in speaker mode, perhaps I could try to figure it out?
Pavel