On Wed, Nov 23, 2011 at 10:48:24AM +0200, Péter Ujfalusi wrote:
On Tuesday 22 November 2011 16:01:05 Mark Brown wrote:
- dmic_clk = clk_get(dmic->dev, "dmic_fck");
- if (IS_ERR(dmic_clk)) {
dev_err(dmic->dev, "cant get dmic_fck\n");return -ENODEV;- }
Why aren't we getting and holding a reference to the clock over the entire lifetime of the driver?
We only need the reference for the dmic_fclk for reparenting which will happen only once in most cases (or not at all, if pad_clks_ck is going to be used). I don't think we should hold the reference for the dmic_fclk. The clock handling is done via pm_runtime_get/put_sync().
This just seems like it's making the code needlessly complex - there's no harm in holding the reference if you don't enable/disable the clock and it makes this function much simpler.
- /* disable clock while reparenting */
- pm_runtime_put_sync(dmic->dev);
- ret = clk_set_parent(dmic_clk, parent_clk);
- pm_runtime_get_sync(dmic->dev);
Since we're only allowing reclocking while idle shouldn't the clock already be disabled? Seems like it ought to be good for power if nothing else...
We enable the clocks at dai_startup for the DMIC (and disable them on dai_shutdown). We can not reparent while the clocks are enabled. This is the reason for this part.
That sounds like the enable is happening too early, then.
+static int omap_dmic_set_clkdiv(struct snd_soc_dai *dai,
int div_id, int div)+{
DMIC clocking is usually fairly simple so it seems surprising that the driver isn't able to figure this out for itself.
The clock towards the external digital mics are based on the DMIC_FCLK rate. In case of DMIC_FCLK = 19.2MHz, 24.576MHz we can select between two dividers which will result different clocks for the external microphones. I would rather leave this decision to the machine driver which knows the external components, and can pick the best divider for them.
If that's what you're doing then it seems like the machine drivers should be use set_sysclk() (or perhaps even the clk API) to set up the rate they're looking for from the visible clock rather than fiddling about with magic divider values. That way they can say exactly what they want directly in terms of the result they're looking for.