This adds the YAML bindings for the Rockchip I2S/TDM audio driver.
Signed-off-by: Nicolas Frattaroli frattaroli.nicolas@gmail.com --- .../bindings/sound/rockchip,i2s-tdm.yaml | 218 ++++++++++++++++++ MAINTAINERS | 1 + 2 files changed, 219 insertions(+) create mode 100644 Documentation/devicetree/bindings/sound/rockchip,i2s-tdm.yaml
diff --git a/Documentation/devicetree/bindings/sound/rockchip,i2s-tdm.yaml b/Documentation/devicetree/bindings/sound/rockchip,i2s-tdm.yaml new file mode 100644 index 000000000000..a04267ccb0f6 --- /dev/null +++ b/Documentation/devicetree/bindings/sound/rockchip,i2s-tdm.yaml @@ -0,0 +1,218 @@ +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/sound/rockchip,i2s-tdm.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Rockchip I2S/TDM Controller + +description: + The Rockchip I2S/TDM Controller is a Time Division Multiplexed + audio interface found in various Rockchip SoCs, allowing up + to 8 channels of audio over a serial interface. + +maintainers: + - Nicolas Frattaroli frattaroli.nicolas@gmail.com + +properties: + compatible: + enum: + - rockchip,px30-i2s-tdm + - rockchip,rk1808-i2s-tdm + - rockchip,rk3308-i2s-tdm + - rockchip,rk3568-i2s-tdm + - rockchip,rv1126-i2s-tdm + + reg: + maxItems: 1 + + interrupts: + maxItems: 1 + + dmas: + minItems: 1 + maxItems: 2 + + dma-names: + minItems: 1 + maxItems: 2 + items: + enum: + - rx + - tx + + clocks: + minItems: 3 + items: + - description: clock for TX + - description: clock for RX + - description: AHB clock driving the interface + - description: + Parent clock for mclk_tx (only required when using mclk-calibrate) + - description: + Parent clock for mclk_rx (only required when using mclk-calibrate) + - description: + Clock for sample rates that are an integer multiple of 8000 + (only required when using mclk-calibrate) + - description: + Clock for sample rates that are an integer multiple of 11025 + (only required when using mclk-calibrate) + + clock-names: + minItems: 3 + items: + - const: mclk_tx + - const: mclk_rx + - const: hclk + - const: mclk_tx_src + - const: mclk_rx_src + - const: mclk_root0 + - const: mclk_root1 + + rockchip,frame-width: + $ref: /schemas/types.yaml#/definitions/uint32 + default: 64 + minimum: 32 + maximum: 512 + description: + Width of a frame, usually slot width multiplied by number of slots. + Must be even. + + resets: + minItems: 1 + maxItems: 2 + description: resets for the tx and rx directions + + reset-names: + minItems: 1 + maxItems: 2 + items: + enum: + - tx-m + - rx-m + + rockchip,cru: + $ref: /schemas/types.yaml#/definitions/phandle + description: + The phandle of the cru. + Required if neither trcm-sync-tx-only nor trcm-sync-rx-only are specified. + + rockchip,grf: + $ref: /schemas/types.yaml#/definitions/phandle + description: + The phandle of the syscon node for the GRF register. + + rockchip,mclk-calibrate: + description: + Switch between two root clocks depending on the audio sample rate. + For integer multiples of 8000 (e.g. 48000 Hz), mclk_root0 is used. + For integer multiples of 11025 (e.g. 44100 Hz), mclk_root1 is used. + type: boolean + + rockchip,trcm-sync-tx-only: + type: boolean + description: Use TX BCLK/LRCK for both TX and RX. + + rockchip,trcm-sync-rx-only: + type: boolean + description: Use RX BCLK/LRCK for both TX and RX. + + "#sound-dai-cells": + const: 0 + + rockchip,i2s-rx-route: + $ref: /schemas/types.yaml#/definitions/uint32-array + description: + Defines the mapping of I2S RX sdis to I2S data bus lines. + By default, they are mapped one-to-one. + rockchip,i2s-rx-route = <3> would mean sdi3 is receiving from data0. + maxItems: 4 + items: + - enum: [0, 1, 2, 3] + + rockchip,i2s-tx-route: + $ref: /schemas/types.yaml#/definitions/uint32-array + description: + Defines the mapping of I2S TX sdos to I2S data bus lines. + By default, they are mapped one-to-one. + rockchip,i2s-tx-route = <3> would mean sdo3 is sending to data0. + maxItems: 4 + items: + - enum: [0, 1, 2, 3] + + rockchip,tdm-fsync-half-frame: + description: Whether to use half frame fsync. + type: boolean + + rockchip,io-multiplex: + description: + Specify that the GPIO lines on the I2S bus are multiplexed such that + the direction (input/output) needs to be dynamically adjusted. + type: boolean + + +required: + - compatible + - reg + - interrupts + - dmas + - dma-names + - clocks + - clock-names + - resets + - reset-names + - rockchip,grf + - "#sound-dai-cells" + +allOf: + - if: + properties: + rockchip,trcm-sync-tx-only: false + rockchip,trcm-sync-rx-only: false + then: + required: + - rockchip,cru + +additionalProperties: false + +examples: + - | + #include <dt-bindings/clock/rk3568-cru.h> + #include <dt-bindings/interrupt-controller/arm-gic.h> + #include <dt-bindings/interrupt-controller/irq.h> + #include <dt-bindings/pinctrl/rockchip.h> + + bus { + #address-cells = <2>; + #size-cells = <2>; + i2s@fe410000 { + compatible = "rockchip,rk3568-i2s-tdm"; + reg = <0x0 0xfe410000 0x0 0x1000>; + interrupts = <GIC_SPI 53 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&cru MCLK_I2S1_8CH_TX>, <&cru MCLK_I2S1_8CH_RX>, + <&cru HCLK_I2S1_8CH>; + clock-names = "mclk_tx", "mclk_rx", "hclk"; + dmas = <&dmac1 3>, <&dmac1 2>; + dma-names = "rx", "tx"; + resets = <&cru SRST_M_I2S1_8CH_TX>, <&cru SRST_M_I2S1_8CH_RX>; + reset-names = "tx-m", "rx-m"; + rockchip,trcm-sync-tx-only; + rockchip,cru = <&cru>; + rockchip,grf = <&grf>; + #sound-dai-cells = <0>; + pinctrl-names = "default"; + pinctrl-0 = + <&i2s1m0_sclktx + &i2s1m0_sclkrx + &i2s1m0_lrcktx + &i2s1m0_lrckrx + &i2s1m0_sdi0 + &i2s1m0_sdi1 + &i2s1m0_sdi2 + &i2s1m0_sdi3 + &i2s1m0_sdo0 + &i2s1m0_sdo1 + &i2s1m0_sdo2 + &i2s1m0_sdo3>; + }; + }; diff --git a/MAINTAINERS b/MAINTAINERS index 106d448e660d..e2cc0357e2b7 100644 --- a/MAINTAINERS +++ b/MAINTAINERS @@ -16119,6 +16119,7 @@ ROCKCHIP I2S TDM DRIVER M: Nicolas Frattaroli frattaroli.nicolas@gmail.com L: linux-rockchip@lists.infradead.org S: Maintained +F: Documentation/devicetree/bindings/sound/rockchip,i2s-tdm.yaml F: sound/soc/rockchip/rockchip_i2s_tdm.*
ROCKCHIP ISP V1 DRIVER