This adds the YAML bindings for the Rockchip I2S/TDM audio driver.
Signed-off-by: Nicolas Frattaroli frattaroli.nicolas@gmail.com --- .../bindings/sound/rockchip,i2s-tdm.yaml | 193 ++++++++++++++++++ 1 file changed, 193 insertions(+) create mode 100644 Documentation/devicetree/bindings/sound/rockchip,i2s-tdm.yaml
diff --git a/Documentation/devicetree/bindings/sound/rockchip,i2s-tdm.yaml b/Documentation/devicetree/bindings/sound/rockchip,i2s-tdm.yaml new file mode 100644 index 000000000000..1e8c1500ba40 --- /dev/null +++ b/Documentation/devicetree/bindings/sound/rockchip,i2s-tdm.yaml @@ -0,0 +1,193 @@ +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/sound/rockchip,i2s-tdm.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Rockchip I2S/TDM Controller + +description: + The Rockchip I2S/TDM Controller is a Time Division Multiplexed + audio interface found in various Rockchip SoCs, allowing up + to 8 channels of audio over a serial interface. + +maintainers: + - Nicolas Frattaroli frattaroli.nicolas@gmail.com + +properties: + compatible: + enum: + - rockchip,px30-i2s-tdm + - rockchip,rk1808-i2s-tdm + - rockchip,rk3308-i2s-tdm + - rockchip,rk3568-i2s-tdm + - rockchip,rv1126-i2s-tdm + + reg: + maxItems: 1 + + interrupts: + maxItems: 1 + + dmas: + minItems: 1 + maxItems: 2 + + dma-names: + minItems: 1 + items: + - const: rx + - const: tx + + clocks: + items: + - description: clock for TX + - description: clock for RX + - description: AHB clock driving the interface + + clock-names: + items: + - const: mclk_tx + - const: mclk_rx + - const: hclk + + rockchip,frame-width: + $ref: /schemas/types.yaml#/definitions/uint32 + default: 64 + minimum: 32 + maximum: 512 + description: + Width of a frame, usually slot width multiplied by number of slots. + Must be even. + + resets: + items: + - description: reset for TX + - description: reset for RX + + reset-names: + items: + - const: tx-m + - const: rx-m + + rockchip,cru: + $ref: /schemas/types.yaml#/definitions/phandle + description: + The phandle of the cru. + Required if both playback and capture are used, i.e. if rockchip,clk-trcm + is 0. + + rockchip,grf: + $ref: /schemas/types.yaml#/definitions/phandle + description: + The phandle of the syscon node for the GRF register. + + rockchip,mclk-calibrate: + description: + Enable mclk source calibration. + type: boolean + + rockchip,trcm-sync-tx-only: + type: boolean + description: Use TX BCLK/LRCK for both TX and RX. + + rockchip,trcm-sync-rx-only: + type: boolean + description: Use RX BCLK/LRCK for both TX and RX. + + "#sound-dai-cells": + const: 0 + + rockchip,i2s-rx-route: + $ref: /schemas/types.yaml#/definitions/uint32-array + description: + Defines the mapping of I2S RX sdis to I2S data bus lines. + By default, they are mapped one-to-one. + items: + - description: which sdi to connect to data line 0 + - description: which sdi to connect to data line 1 + - description: which sdi to connect to data line 2 + - description: which sdi to connect to data line 3 + + rockchip,i2s-tx-route: + $ref: /schemas/types.yaml#/definitions/uint32-array + description: + Defines the mapping of I2S TX sdos to I2S data bus lines. + By default, they are mapped one-to-one. + items: + - description: which sdo to connect to data line 0 + - description: which sdo to connect to data line 1 + - description: which sdo to connect to data line 2 + - description: which sdo to connect to data line 3 + + rockchip,tdm-fsync-half-frame: + description: Whether to use half frame fsync. + type: boolean + + +required: + - compatible + - reg + - interrupts + - dmas + - dma-names + - clocks + - clock-names + - resets + - reset-names + - rockchip,grf + - "#sound-dai-cells" + +allOf: + - if: + properties: + rockchip,trcm-sync-tx-only: false + rockchip,trcm-sync-rx-only: false + then: + required: + - rockchip,cru + +additionalProperties: false + +examples: + - | + #include <dt-bindings/clock/rk3568-cru.h> + #include <dt-bindings/interrupt-controller/arm-gic.h> + #include <dt-bindings/interrupt-controller/irq.h> + #include <dt-bindings/pinctrl/rockchip.h> + + foo { + #address-cells = <2>; + #size-cells = <2>; + i2s@fe410000 { + compatible = "rockchip,rk3568-i2s-tdm"; + reg = <0x0 0xfe410000 0x0 0x1000>; + interrupts = <GIC_SPI 53 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&cru MCLK_I2S1_8CH_TX>, <&cru MCLK_I2S1_8CH_RX>, + <&cru HCLK_I2S1_8CH>; + clock-names = "mclk_tx", "mclk_rx", "hclk"; + dmas = <&dmac1 3>, <&dmac1 2>; + dma-names = "rx", "tx"; + resets = <&cru SRST_M_I2S1_8CH_TX>, <&cru SRST_M_I2S1_8CH_RX>; + reset-names = "tx-m", "rx-m"; + rockchip,trcm-sync-tx-only; + rockchip,cru = <&cru>; + rockchip,grf = <&grf>; + #sound-dai-cells = <0>; + pinctrl-names = "default"; + pinctrl-0 = + <&i2s1m0_sclktx + &i2s1m0_sclkrx + &i2s1m0_lrcktx + &i2s1m0_lrckrx + &i2s1m0_sdi0 + &i2s1m0_sdi1 + &i2s1m0_sdi2 + &i2s1m0_sdi3 + &i2s1m0_sdo0 + &i2s1m0_sdo1 + &i2s1m0_sdo2 + &i2s1m0_sdo3>; + status = "okay"; + }; + };