On Thu, 13 Jun 2024 10:26:33 +0200, Baojun Xu wrote:
--- a/sound/pci/hda/Makefile +++ b/sound/pci/hda/Makefile @@ -70,6 +70,8 @@ obj-$(CONFIG_SND_HDA_SCODEC_CS35L56_SPI) += snd-hda-scodec-cs35l56-spi.o obj-$(CONFIG_SND_HDA_CS_DSP_CONTROLS) += snd-hda-cs-dsp-ctls.o obj-$(CONFIG_SND_HDA_SCODEC_COMPONENT) += snd-hda-scodec-component.o obj-$(CONFIG_SND_HDA_SCODEC_TAS2781_I2C) += snd-hda-scodec-tas2781-i2c.o +obj-$(CONFIG_SND_HDA_SCODEC_TAS2781_SPI) += snd-hda-scodec-tas2781-spi.o +snd-hda-scodec-tas2781-spi-y := tas2781_hda_spi.o tas2781_spi_fwlib.o
Try to put *-y addition to the right place. There are the section defining snd-hda-codec-*-y.
+#define TASDEVICE_REG(book, page, reg) (((book & GENMASK(7, 0)) << 16) + \
((page & GENMASK(7, 0)) << 8) + \((reg & GENMASK(6, 0)) << 1))
Usually bits are combined with '|', not '+'.
+/* Firmware block Checksum */ +#define TASDEVICE_Checksum TASDEVICE_REG(0x0, 0x0, 0x7e)
Use capital letters.
... and at this point, I noticed that the patch doesn't contain the code for sound/pci/hda/tas2781_spi_fwlib.c at all. The patch must be utterly broken.
*PLEASE* try to apply and build the patch to submit beforehand from the clean state and verify it really works.
thanks,
Takashi