On 03/01/2016 10:12 AM, Takashi Iwai wrote:
On Tue, 01 Mar 2016 09:19:14 +0100, Arnaud Pouliquen wrote:
Add IEC958 channel status helper that creates control to handle the IEC60958 status bits.
Signed-off-by: Arnaud Pouliquen arnaud.pouliquen@st.com
What is the reason to make the mutex pointer instead of the own one? Any need for sharing the mutex?
Yes, need to share mutex to avoid race condition between control update and action on pcm stream ( hw_param or prepare)
And, if it has to be assigned explicitly by user, you have to write it explicitly, too.
ok, if not enough explicit, i will add comment in snd_pcm_iec958_params definition
Another small nitpicking:
+static int snd_pcm_iec958_put(struct snd_kcontrol *kcontrol,
struct snd_ctl_elem_value *uctl)+{
- struct snd_pcm_iec958_params *params = snd_kcontrol_chip(kcontrol);
- int err = 0;
- if (!params->mutex)
return -EINVAL;- mutex_lock(params->mutex);
- if (params->ctrl_set)
err = params->ctrl_set(params->pdata,uctl->value.iec958.status);So, in your design, ctrl_set isn't mandatory?
Hypothesis is that for some hardwares, callback is not needed, only channels status values are needed. As example some hardwares could not want to support switch from audio to none-audio mode without stopping PCM.
+int snd_pcm_create_iec958_ctl(struct snd_pcm *pcm,
struct snd_pcm_iec958_params *params, int stream)+{
- struct snd_kcontrol_new knew;
- if (stream > SNDRV_PCM_STREAM_LAST)
return -EINVAL;- knew = iec958_ctls[stream];
- knew.device = pcm->device;
- knew.index = pcm->device;
- knew.count = pcm->streams[stream].substream_count;
Hmm, this doesn't always work. It will create the substream_count ctls starting from the pcm dev# as index. What if there are 2 PCM devices where both contain 4 substreams?
I admit that the current ctl <-> PCM mapping is messing. There are some heuristics and you're trying to follow that. But blindly applying to all cases doesn't seem to work.
yes this is not clean. i'm not very familiar with substream usage, so any suggestion is welcome. The only use case I have in mind is a HDMI connected through 4 I2S data wire... I can see 2 options: - Associate control only to pcm device. - Create a control per sub-device
Do we really need to associate one IEC control per substream?
Thanks Arnaud