At Sun, 27 Jan 2008 23:03:20 +0100, Martin Egge wrote:
Hi Takashi,
Am Mittwoch, 23. Januar 2008 schrieb Takashi Iwai:
The SPDIF is disabled intentionally for your model because no one could test it. Does the patch below work?
As I already have written: this patch does not work with the code from hg. But I've applied it successfully on 1.0.15. The digital output is working and can be disabled with the IEC958 switch.
Using the code from hg the digital output is not working as well when I set model=3stack. This has has been working with the original code from 1.0.15 and 1.0.14. So there must be a general problem with IEC958 in the hg code.
OK, then again, get the codec dump to compare.
I've another question regarding the digital output. Is there a way to control the volume of the digital output? Neither the Master nor the PCM control have any effect on the volume of the digital output. In addition the output can't be switched off by muting PCM or Master.
No, this signal route has no volume control.
Takashi