Changeset 5513b411ea5b ("Documentation: rename pinctl to pin-control") renamed: Documentation/driver-api/pinctl.rst to: Documentation/driver-api/pin-control.rst.
Update the cross-references accordingly.
Fixes: 5513b411ea5b ("Documentation: rename pinctl to pin-control") Signed-off-by: Mauro Carvalho Chehab mchehab+huawei@kernel.org --- include/linux/device.h | 2 +- include/linux/mfd/madera/pdata.h | 2 +- include/linux/pinctrl/pinconf-generic.h | 2 +- 3 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/include/linux/device.h b/include/linux/device.h index 38a2071cf776..d1183cfdc8fb 100644 --- a/include/linux/device.h +++ b/include/linux/device.h @@ -399,7 +399,7 @@ struct dev_links_info { * along with subsystem-level and driver-level callbacks. * @em_pd: device's energy model performance domain * @pins: For device pin management. - * See Documentation/driver-api/pinctl.rst for details. + * See Documentation/driver-api/pin-control.rst for details. * @msi_list: Hosts MSI descriptors * @msi_domain: The generic MSI domain this device is using. * @numa_node: NUMA node this device is close to. diff --git a/include/linux/mfd/madera/pdata.h b/include/linux/mfd/madera/pdata.h index 601cbbc10370..32e3470708ed 100644 --- a/include/linux/mfd/madera/pdata.h +++ b/include/linux/mfd/madera/pdata.h @@ -31,7 +31,7 @@ struct pinctrl_map; * @irq_flags: Mode for primary IRQ (defaults to active low) * @gpio_base: Base GPIO number * @gpio_configs: Array of GPIO configurations (See - * Documentation/driver-api/pinctl.rst) + * Documentation/driver-api/pin-control.rst) * @n_gpio_configs: Number of entries in gpio_configs * @gpsw: General purpose switch mode setting. Depends on the external * hardware connected to the switch. (See the SW1_MODE field diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h index e18ab3d5908f..5a96602a3316 100644 --- a/include/linux/pinctrl/pinconf-generic.h +++ b/include/linux/pinctrl/pinconf-generic.h @@ -89,7 +89,7 @@ struct pinctrl_map; * it. * @PIN_CONFIG_OUTPUT: this will configure the pin as an output and drive a * value on the line. Use argument 1 to indicate high level, argument 0 to - * indicate low level. (Please see Documentation/driver-api/pinctl.rst, + * indicate low level. (Please see Documentation/driver-api/pin-control.rst, * section "GPIO mode pitfalls" for a discussion around this parameter.) * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset * @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power