On Fri, Dec 01, 2017 at 08:56:31AM -0600, Andrew F. Davis wrote:
Personally I wouldn't have put MicBias voltage in DT to begin with, it is runtime configurable and depends on user runtime inserted microphone, not really a hardware description :/
Usually the system as a whole is specified to have some particular kind of microphone attached (or soldered in) and this follows from that. There's typically also soldered down analogue components that are selected based on the bias voltage so a specific system likely won't have the full flexibility.
The enable/disable is controlled by a DAPM and should be wired to enable whenever we are recording from the related microphone pin. So then without MICBIAS_OFF the user is forced to select from the above voltages whenever recording, which may not be correct if they are using a mic that doesn't need bias.
That'd depend on someone having a board that was able to detect that a line input was plugged in or a user control for this. If the board was permenantly set up for line input presumably the bias wouldn't even be wired up.