This patch enables a PiFi DAC+ V2.0, which is a PCM5122-based audio output DAC add-on board for the Raspberry Pi B+ and later, connected to the GPIO header of the Bananapi M3 via jumper cables. The power, ground, and I2C pins are in the same position, but the I2S ones are not.
The I2C controller used is I2C2, while the I2S controller is I2S1.
Signed-off-by: Chen-Yu Tsai wens@csie.org ---
I'm sure I've asked this before, and IIRC the answer was yes: The I2C controllers available on the GPIO header all have proper, always-on, external pull-ups. Does that mean we can enable them by default, seeing as they are likely intended to be used this way (as I2C pins)?
I think we have a few boards where either I2C or UARTs on the GPIO header are enabled by default.
--- arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts | 33 ++++++++++++++++++++++++++++ 1 file changed, 33 insertions(+)
diff --git a/arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts b/arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts index 6550bf0e594b..a9a208ebda12 100644 --- a/arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts +++ b/arch/arm/boot/dts/sun8i-a83t-bananapi-m3.dts @@ -70,6 +70,23 @@ gpio = <&pio 3 24 GPIO_ACTIVE_HIGH>; /* PD24 */ };
+ sound { + compatible = "simple-audio-card"; + simple-audio-card,name = "PiFi DAC+ v2.0"; + simple-audio-card,format = "i2s"; + simple-audio-card,mclk-fs = <512>; + simple-audio-card,frame-master = <&link_cpu>; + simple-audio-card,bitclock-master = <&link_cpu>; + + link_cpu: simple-audio-card,cpu { + sound-dai = <&i2s1>; + }; + + simple-audio-card,codec { + sound-dai = <&pcm5122>; + }; + }; + wifi_pwrseq: wifi_pwrseq { compatible = "mmc-pwrseq-simple"; clocks = <&ac100_rtc 1>; @@ -100,6 +117,22 @@ status = "okay"; };
+&i2c2 { + pinctrl-names = "default"; + pinctrl-0 = <&i2c2_ph_pins>; + status = "okay"; + + pcm5122: pcm5122@4d { + #sound-dai-cells = <0>; + compatible = "ti,pcm5122"; + reg = <0x4d>; + }; +}; + +&i2s1 { + status = "okay"; +}; + &mdio { rgmii_phy: ethernet-phy@1 { compatible = "ethernet-phy-ieee802.3-c22";