Timeslots setting is done at channel start() and stop(). There is no more need to do that during setup_chan().
Simply remove timeslot setting from setup_chan().
Signed-off-by: Herve Codina herve.codina@bootlin.com Reviewed-by: Christophe Leroy christophe.leroy@csgroup.eu --- drivers/soc/fsl/qe/qmc.c | 28 ---------------------------- 1 file changed, 28 deletions(-)
diff --git a/drivers/soc/fsl/qe/qmc.c b/drivers/soc/fsl/qe/qmc.c index bc72c1bc0ec4..45d9cb40a118 100644 --- a/drivers/soc/fsl/qe/qmc.c +++ b/drivers/soc/fsl/qe/qmc.c @@ -723,30 +723,6 @@ static int qmc_chan_setup_tsa_rx(struct qmc_chan *chan, bool enable) return qmc_chan_setup_tsa_32rx(chan, &info, enable); }
-static int qmc_chan_setup_tsa(struct qmc_chan *chan, bool enable) -{ - struct tsa_serial_info info; - int ret; - - /* Retrieve info from the TSA related serial */ - ret = tsa_serial_get_info(chan->qmc->tsa_serial, &info); - if (ret) - return ret; - - /* - * Setup one common 64 entries table or two 32 entries (one for Tx - * and one for Tx) according to assigned TS numbers. - */ - if (chan->qmc->is_tsa_64rxtx) - return qmc_chan_setup_tsa_64rxtx(chan, &info, enable); - - ret = qmc_chan_setup_tsa_32rx(chan, &info, enable); - if (ret) - return ret; - - return qmc_chan_setup_tsa_32tx(chan, &info, enable); -} - static int qmc_chan_command(struct qmc_chan *chan, u8 qmc_opcode) { return cpm_command(chan->id << 2, (qmc_opcode << 4) | 0x0E); @@ -1321,10 +1297,6 @@ static int qmc_setup_chan(struct qmc *qmc, struct qmc_chan *chan)
chan->qmc = qmc;
- ret = qmc_chan_setup_tsa(chan, true); - if (ret) - return ret; - /* Set channel specific parameter base address */ chan->s_param = qmc->dpram + (chan->id * 64); /* 16 bd per channel (8 rx and 8 tx) */