On 3/13/20 4:56 AM, Matt Flax wrote:
On 13/3/20 10:19 am, Matt Flax wrote:
On 13/3/20 9:55 am, Pierre-Louis Bossart wrote:
On 3/11/20 5:54 PM, Matt Flax wrote:
Hi there,
A large number of audio codecs allow different formats for playback and capture. This becomes very useful when there are different latencies between playback and capture hardware data lines. For example digital isolation chips typically have a 1 bit delay in propagation as the bit clock rate gets faster for higher sample rates. By setting the capture and playback formats to differ by one or two bit clock cycles, the delay problem is solved.
There doesn't seem to be a simple way to detect stream direction in the codec driver's set_fmt function.
The snd_soc_runtime_set_dai_fmt function :
https://github.com/torvalds/linux/blob/master/sound/soc/soc-core.c#L1480
calls the snd_soc_dai_set_fmt function :
https://github.com/torvalds/linux/blob/master/sound/soc/soc-dai.c#L101
which calls the set_fmt function :
https://github.com/torvalds/linux/blob/master/include/sound/soc-dai.h#L189
The snd_soc_dai_ops set_fmt function is defined as :
int (*set_fmt)(struct snd_soc_dai *dai, unsigned int fmt);
Is there a simple way to find the stream direction from a snd_soc_dai ?
If the stream direction can be detected then the playback and capture formats can be set independently for the codec.
It there a different way to set the playback and capture formats for the codec independently at runtime, depending on the sample rate ?
FWIW I remember a discussion in the past on how to deal with interfaces that may have different clocks sources for capture and playback (typically with the 6-pin version of I2S/TDM), and the answer was: use two dais, with one dealing with capture and the other with playback.
I would bet this applies for the format as well. If you use a DAI that can do both directions, then indeed there's no obvious way to specify that formats or clock ownership could be different between the two directions.
It would probably make sense anyway to have a representation with two dais, e.g. the codec capture dai receives data from somewhere and the codec playback dai forwards it to another destination.
I think I get it ...
This approach would keep extra stream selective functionality out of soc-dai.c. That is probably a good thing for the simplicity of the core.
A machine driver could then call snd_soc_dai_set_fmt passing in the correct codec_dai from the codec_dais array for the stream they want to operate on.
In an example case, cs4271 ... how do we enforce symmetric rates ?
You'd have to do this manually in your driver. The core itself does not support synchronizing streams on different DAIs.
You can do this by saving the rate when it is set on the first stream and then apply a constraint to the second stream using snd_pcm_hw_constraint_single() it the driver's startup() callback.
Have a look at the uda134x.c or twl4030.c driver as an example.
But I think Pierre was mainly talking about the case where there are separate clocks for each direction and the rates don't have to be the same. I believe long term it might make sense to extend the core to allow different formats for input and output direction on the same DAI.
- Lars