On 03/19/2015 08:06 PM, Nikolay Dimitrov wrote:
Slight clarification here - I can't find any such reference in the SGTL5000 datasheet where it's explicitly written that the I2C bus *requires* the MCLK running. Unfortunately, all of us found this obscure dependency empirically.
It is not spelled out as such, but in: http://cache.freescale.com/files/analog/doc/data_sheet/SGTL5000.pdf?pspll=1 bottom of page9 (note 1) and the power up sequence in page10. See also page13, RESET section.
If you change audio controls while you don't have audio activity, you will still need to have the MCLK running.
Correct. And this is a big issue. As far as I know, the kernel drivers control separately the clock domains, and separately i2c devices, so the basic expectation on the kernel side is that there's no connection between these 2. In this specific case, because of the SGTL5000's implementation, there's a dependency. Right now as I see it, there are several ways to resolve it:
- Run the reference clock all the time, so the SGTL5000 codec is
happy, and DAPM widgets can work as-is. We've been doing this all the time - the reference clocks are routinely configured either in the bootloader, or in the DTS iomuxc node. While this can work in some cases (or until someone touches the same clock or one of its parents :D), there are other cases (like battery-powered devices) where people would want more aggressive power management, which means controlling the reference clock at runtime (see #2).
Note the the codec driver will enable the clock and will not let it to be turned off. You need to work on the codec driver to sort this out.
- Add "hacks" in the DAPM widgets that add control to the codec's
reference clocks. While this seems the preferred route to many, the general feeling is that such approach is not very welcome in upstream.
SND_SOC_DAPM_CLOCK_SUPPLY()
- Add explicit support in the kernel's audio subsystem for
dependencies between i2c devices and clocks, maybe via "DAPM clock widget" or something like this. Provided that the DAPM graphs are defined properly, this will work out-of-the-box for all use cases, without the hacks (until we see even more twisted cases).
This can be handled within the codec driver with some changes. If you have external clock which can be enabled/diabled with a GPIO, then you can use that. We already have binding for this type of external clocks (in linux-next): look for "gpio-gate-clock" You define your external GPIO controlled clock with this binding and use the phandle in the codec driver. Change the codec driver to enable/disable the clock when needed. When you do not have audio activity, set the regmap to cache only so any change in the controls will not reach the HW. When you power up next time the regmap will sync the changes to the chip, so you will have the changes commited.