SAMA7G5's I2S-MCC has 4 pairs of DIN/DOUT pins. Since TDM only uses a single pair of pins for synchronous capture and playback, the controller needs to be told which of the pair is connected. This can be mentioned using the new "microchip,tdm-data-pair" property. The property is optional, needed only if TDM is used, and if it's missing DIN/DOUT 0 pins will be used by default.
Signed-off-by: Codrin Ciubotariu codrin.ciubotariu@microchip.com ---
Changes in v2: - changes are done to mchp-i2s-mcc.txt insted of mchp,i2s-mcc.yaml
Documentation/devicetree/bindings/sound/mchp-i2s-mcc.txt | 7 ++++++- 1 file changed, 6 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/sound/mchp-i2s-mcc.txt b/Documentation/devicetree/bindings/sound/mchp-i2s-mcc.txt index 2180dbd9ea81..af8fe3e657df 100644 --- a/Documentation/devicetree/bindings/sound/mchp-i2s-mcc.txt +++ b/Documentation/devicetree/bindings/sound/mchp-i2s-mcc.txt @@ -19,7 +19,12 @@ Required properties: Optional properties: - pinctrl-0: Should specify pin control groups used for this controller. - princtrl-names: Should contain only one value - "default". - +- microchip,tdm-data-pair: 8 bit value that represents the DIN/DOUT pair pins + which are used to receive/send TDM data. It is optional + and it is only needed if the controller uses the TDM + mode. Not available for "microchip,sam9x60-i2smcc" + compatible. If it's not present, the default value is 0, + so the DIN/DOUT 0 pins are used.
(1) : Only the peripheral clock is required. The generated clock is optional and should be set mostly when Master Mode is required.