With this change, I can capture from a microphone plugged into the mic jack on Harmony (after unmuting Left Input PGA, and maybe turning up the gain there too).
Signed-off-by: Stephen Warren swarren@nvidia.com --- Question: Harmony has a mono mic attached to the left input channel. However, the I2S controller only supports stereo. Is it possible to duplicate the mic input to both channels in ALSA? I know the WM8903 can do it via the WM8903_AUDIO_INTERFACE_0 register, but I'm not sure how to request that in ALSA-speak. It looks like this same setup applies to many other platforms, but I couldn't see how the issue was solved, if at all.
sound/soc/tegra/harmony.c | 31 +++++++++++++++++++++++++++++++ 1 files changed, 31 insertions(+), 0 deletions(-)
diff --git a/sound/soc/tegra/harmony.c b/sound/soc/tegra/harmony.c index bf0dbaf..b160b71 100644 --- a/sound/soc/tegra/harmony.c +++ b/sound/soc/tegra/harmony.c @@ -107,6 +107,36 @@ static struct snd_soc_ops harmony_asoc_ops = { .hw_params = harmony_asoc_hw_params, };
+static const struct snd_soc_dapm_widget harmony_dapm_widgets[] = { + SND_SOC_DAPM_HP("Headphone Jack", NULL), + SND_SOC_DAPM_MIC("Mic Jack", NULL), +}; + +static const struct snd_soc_dapm_route harmony_audio_map[] = { + {"Headphone Jack", NULL, "HPOUTR"}, + {"Headphone Jack", NULL, "HPOUTL"}, + {"Mic Bias", NULL, "Mic Jack"}, + {"IN1L", NULL, "Mic Bias"}, +}; + +static int harmony_asoc_init(struct snd_soc_pcm_runtime *rtd) +{ + struct snd_soc_codec *codec = rtd->codec; + struct snd_soc_dapm_context *dapm = &codec->dapm; + + snd_soc_dapm_new_controls(dapm, harmony_dapm_widgets, + ARRAY_SIZE(harmony_dapm_widgets)); + + snd_soc_dapm_add_routes(dapm, harmony_audio_map, + ARRAY_SIZE(harmony_audio_map)); + + snd_soc_dapm_enable_pin(dapm, "Headphone Jack"); + snd_soc_dapm_enable_pin(dapm, "Mic Jack"); + snd_soc_dapm_sync(dapm); + + return 0; +} + static struct snd_soc_dai_link harmony_wm8903_dai = { .name = "WM8903", .stream_name = "WM8903 PCM", @@ -114,6 +144,7 @@ static struct snd_soc_dai_link harmony_wm8903_dai = { .platform_name = "tegra-pcm-audio", .cpu_dai_name = "tegra-i2s.0", .codec_dai_name = "wm8903-hifi", + .init = harmony_asoc_init, .ops = &harmony_asoc_ops, };