On Thu, Jul 25, 2013 at 08:16:04PM +0100, Mark Brown wrote:
On Thu, Jul 25, 2013 at 11:14:28AM +0200, Jean-Francois Moine wrote:
To avoid the declaration of a 'kirkwood-pcm-audio' device in the DT, this patch merges the kirkwood-i2c and kirkwood-dma drivers into one module.
This seems mostly fine, though it may be best to keep kirkwood-dma as a separate module for the benefit of the S/PDIF support when it gets added
- I had a look at the implementation Russell has and it looks like it
can be added as a separate interface.
You wouldn't want I2S and SPDIF to be separate modules though - they're the same hardware but different output stream formatters attached to the DMA FIFO output. Don't forget the requirements concerning the simultaneous use of I2S and SPDIF - these "output formatters" must both be enabled and disabled in unison when concurrent use is required - both bits must be set or cleared together with a single register write.
- .platform_name = "kirkwood-pcm-audio",
- .platform_name = "kirkwood-i2s",
Should the name be done as dev_name() for the interface (I don't know if there is ever more than one)?
Getting away from "kirkwood-i2s" would be sensible, because it may not be just "i2s" in this hardware block. The documentation calls this an "audio controller" but I guess "kirkwood-pcm" would be a reasonable compromise, even though it has a separate AC'97 block which could also be construed as being "pcm".
The AC'97 block uses a separate peripheral DMA controller and so wouldn't make use of kirkwood-dma.c either.