19 Sep
2012
19 Sep
'12
4:50 a.m.
On Fri, Sep 14, 2012 at 04:57:37PM +0530, Ashish Chavan wrote:
This looks like a good improvement, a few issues remain though:
- /* DAC Routing control */
- SOC_ENUM("DAC Left Select", da9055_dac_l_select),
- SOC_ENUM("DAC Right Select", da9055_dac_r_select),
DAPM. This even says its a routing control...
- /* To select if MIC Bias powers MIC 1 or MIC 2 */
- SOC_ENUM("Mic Bias Select", da9055_mic_bias_select),
This would normally be something controlled by the board... what exactly is this doing? How does the MICBIAS relate to the microphone inputs?
- case SND_SOC_BIAS_STANDBY:
if (codec->dapm.bias_level == SND_SOC_BIAS_OFF) {
/* Enable VMID reference & master bias */
snd_soc_update_bits(codec, DA9055_REFERENCES,
DA9055_VMID_EN | DA9055_BIAS_EN,
DA9055_VMID_EN | DA9055_BIAS_EN);
}
regcache_sync(da9055->regmap);
Doing the sync every time is very odd, why is it only done on transitions from _OFF? Given that there's no regulator support here it's also a bit surprising that you need to do a sync outside of system suspend...
- da9055->mclk_rate = 0; /* This will be set from set_sysclk() */
- da9055->master = 0; /* This will be set from set_fmt() */
You use kzalloc...