On Wed, 08 Jun 2016 21:42:45 +0200, han.lu@intel.com wrote:
From: "Lu, Han" han.lu@intel.com
Add noise detection for alsabat. Alsabat reports error when noise above threshold be detected. Use either of the options below to designate the threshold. (e.g. if the ratio of noise to signal is 5%, the snr is about 26dB.) --snr-db <value in dB> --snr-pc <value in %>
The noise detection is performed in time domain. On each period of the sine wave being analyzed, alsabat substracts a clean sine wave from the source, calculates the RMS value of the residual, and compares the result with the threshold. At last, alsabat returns the number of periods with noise above threshold. 0 is returned when the source is clean.
patch content:
- align the data type and process on float
- add a parameter for adjust_waveform()
- add a single channel sine wave generator
- add noise detection
Lu, Han (4): alsabat: align the data type on float alsabat: add channels parameter for adjust_waveform() alsabat: add a single channel sine wave generator alsabat: add noise detection
Applied all patches now. Thanks.
Takashi