On 06/07/2013 01:53 PM, Daniel Mack wrote:
The ADAU1701 has 2 hardware pins to configure the PLL mode in accordance to the MCLK-to-LRCLK ratio. These pins have to be stable before the chip is released from reset, and a full reset cycle, including a new firmware download is needed whenever they change.
I think it makes more sense to let the user provide the mclk frequency and then let the driver in the hwparams callback choose the right divider based on the select playback rate.
This patch adds GPIO properties to the DT bindings of the Codec, and implements a callback for the set_clkdiv callback of the DAI.
To avoid excessive reset cycles and firmware downloads, the default clock divider can be specified in DT as well.
Signed-off-by: Daniel Mack zonque@gmail.com
.../devicetree/bindings/sound/adi,adau1701.txt | 13 ++++ sound/soc/codecs/adau1701.c | 74 ++++++++++++++++++++++ sound/soc/codecs/adau1701.h | 4 ++ 3 files changed, 91 insertions(+)
diff --git a/Documentation/devicetree/bindings/sound/adi,adau1701.txt b/Documentation/devicetree/bindings/sound/adi,adau1701.txt index 3afeda7..c9c6e98 100644 --- a/Documentation/devicetree/bindings/sound/adi,adau1701.txt +++ b/Documentation/devicetree/bindings/sound/adi,adau1701.txt @@ -11,6 +11,19 @@ Optional properties:
- reset-gpio: A GPIO spec to define which pin is connected to the chip's !RESET pin. If specified, the driver will assert a hardware reset at probe time.
- adi,pll-clkdiv: The PLL clock divider, specifing the ratio between
MCLK and fsclk. The value is used to determine thecorrect state of the two mode pins below.Note that this value can be overridden at runtimeby passing the ADAU1701_CLKDIV_MCLK_LRCLK dividerwith ASoC calls. However, the chips needs a fullreset cycle and a new firmware download each timethe configuration changes.
- adi,pll-mode0-gpio,
- adi,pll-mode1-gpio: GPIO specs to describe the GPIOs the ADAU's PLL config
pins are connected to. The state of the pins are setaccording to the configured clock divider on ASoC sidebefore the firmware is loaded.
I'd make this one property with two gpios, e.g.:
adi,pll-mode-gpios = <&gpio 12 0 &gpio 34 0>;
- Lars