From: Jorge Eduardo Candelaria jorge.candelaria@ti.com
On Phoenix 1.1, the INTID register default value is an invalid one, causing the interrupt handler to think the phoenix power on sequence is ready before it actually finishes.
This causes some i2c errors when trying to configure twl.
Signed-off-by: Jorge Eduardo Candelaria jorge.candelaria@ti.com Signed-off-by: Margarita Olaya Cabrera magi.olaya@ti.com --- sound/soc/codecs/twl6040.c | 21 +++++++++++---------- 1 files changed, 11 insertions(+), 10 deletions(-)
diff --git a/sound/soc/codecs/twl6040.c b/sound/soc/codecs/twl6040.c index b2402ae..17a8715 100644 --- a/sound/soc/codecs/twl6040.c +++ b/sound/soc/codecs/twl6040.c @@ -1627,6 +1627,17 @@ static int twl6040_probe(struct snd_soc_codec *codec) goto gpio2_err;
priv->codec_powered = 0; + + /* enable only codec ready interrupt */ + twl6040_write(codec, TWL6040_REG_INTMR, + ~TWL6040_READYMSK & TWL6040_ALLINT_MSK); + + /* reset interrupt status to allow correct power up sequence */ + twl6040_read_reg_volatile(codec, TWL6040_REG_INTID); + } else { + /* no interrupts at all */ + twl6040_write_reg_cache(codec, TWL6040_REG_INTMR, + TWL6040_ALLINT_MSK); }
if (naudint) { @@ -1637,16 +1648,6 @@ static int twl6040_probe(struct snd_soc_codec *codec) "twl6040_codec", codec); if (ret) goto gpio2_err; - } else { - if (gpio_is_valid(audpwron)) { - /* enable only codec ready interrupt */ - twl6040_write_reg_cache(codec, TWL6040_REG_INTMR, - ~TWL6040_READYMSK & TWL6040_ALLINT_MSK); - } else { - /* no interrupts at all */ - twl6040_write_reg_cache(codec, TWL6040_REG_INTMR, - TWL6040_ALLINT_MSK); - } }
/* init vio registers */