Add properties for configuring the General Purpose Outputs (GPO). The GPOs. There are 2 settings for each GPO, configuration and the output drive type.
Signed-off-by: Dan Murphy dmurphy@ti.com --- .../bindings/sound/tlv320adcx140.yaml | 28 +++++++++++++++++++ 1 file changed, 28 insertions(+)
diff --git a/Documentation/devicetree/bindings/sound/tlv320adcx140.yaml b/Documentation/devicetree/bindings/sound/tlv320adcx140.yaml index 2e6ac5d2ee96..0950eb69f2b2 100644 --- a/Documentation/devicetree/bindings/sound/tlv320adcx140.yaml +++ b/Documentation/devicetree/bindings/sound/tlv320adcx140.yaml @@ -108,6 +108,32 @@ properties: maximum: 7 default: [0, 0, 0, 0]
+patternProperties: + '^ti,gpo-config-[1-4]$': + $ref: /schemas/types.yaml#/definitions/uint32-array + description: | + Defines the configuration and output driver for the general purpose + output pins (GPO). These values are pairs, the first value is for the + configuration type and the second value is for the output drive type. + The array is defined as <GPO_CFG GPO_DRV> + + GPO output configuration can be one of the following: + + 0 - (default) disabled + 1 - GPOX is configured as a general-purpose output (GPO) + 2 - GPOX is configured as a device interrupt output (IRQ) + 3 - GPOX is configured as a secondary ASI output (SDOUT2) + 4 - GPOX is configured as a PDM clock output (PDMCLK) + + GPO output drive configuration for the GPO pins can be one of the following: + + 0d - (default) Hi-Z output + 1d - Drive active low and active high + 2d - Drive active low and weak high + 3d - Drive active low and Hi-Z + 4d - Drive weak low and active high + 5d - Drive Hi-Z and active high + required: - compatible - reg @@ -124,6 +150,8 @@ examples: ti,mic-bias-source = <6>; ti,pdm-edge-select = <0 1 0 1>; ti,gpi-config = <4 5 6 7>; + ti,gpo-config-1 = <0 0>; + ti,gpo-config-2 = <0 0>; reset-gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>; }; };