+static int __maybe_unused amd_pm_prepare(struct device *dev) +{
- struct amd_sdwc_ctrl *ctrl = dev_get_drvdata(dev);
- struct sdw_bus *bus = &ctrl->bus;
- int ret;
- if (bus->prop.hw_disabled || !ctrl->startup_done) {
dev_dbg(bus->dev, "SoundWire master %d is disabled or not-started, ignoring\n",bus->link_id);return 0;- }
- ret = device_for_each_child(bus->dev, NULL, amd_resume_child_device);
- if (ret < 0)
dev_err(dev, "%s: amd_resume_child_device failed: %d\n", __func__, ret);- if (pm_runtime_suspended(dev) && ctrl->power_mode_mask & AMD_SDW_CLK_STOP_MODE) {
ret = pm_request_resume(dev);if (ret < 0) {dev_err(bus->dev, "pm_request_resume failed: %d\n", ret);return 0;}- }
- return 0;
+}
This seems to be inspired by the Intel code, but is this necessary here?
No It's not inspired by intel code. Initially, we haven't included pm_prepare callback. We have observed issues without pm_prepare callback.
For Intel, we saw cases where we had to pm_resume before doing a system suspend, otherwise the hardware was in a bad state.
Do you actually need to do so, or is is possible to do a system suspend when the clock is stopped.
And in the case where the bus is in 'power-off' mode, do you actually need to resume at all?
Our platform supports different power modes. To support all combinations, we have included pm_prepare callback.
do you actually need to stop the clock before powering-off? This seems counter intuitive and not so useful?
Yes, as per our design, we need to stop the clock before powering off.
It'd be good to add comments capturing these points, that would be useful for new contributors and reviewers to know this is intentional and required by the hardware programming sequences.