Existing code used SSP2, make selection of SSP id dependent on port name. This is required when the machine driver uses non-default settings
Signed-off-by: Pierre-Louis Bossart pierre-louis.bossart@linux.intel.com --- sound/soc/intel/atom/sst-atom-controls.c | 15 ++++++++++++--- 1 file changed, 12 insertions(+), 3 deletions(-)
diff --git a/sound/soc/intel/atom/sst-atom-controls.c b/sound/soc/intel/atom/sst-atom-controls.c index 28eea12..0838478 100644 --- a/sound/soc/intel/atom/sst-atom-controls.c +++ b/sound/soc/intel/atom/sst-atom-controls.c @@ -935,17 +935,26 @@ void sst_fill_ssp_defaults(struct snd_soc_dai *dai) int send_ssp_cmd(struct snd_soc_dai *dai, const char *id, bool enable) { struct sst_data *drv = snd_soc_dai_get_drvdata(dai); - const struct sst_ssp_config *config; + int ssp_id;
dev_info(dai->dev, "Enter: enable=%d port_name=%s\n", enable, id);
+ if (strcmp(id, "ssp0-port") == 0) + ssp_id = SSP_MODEM; + else if (strcmp(id, "ssp2-port") == 0) + ssp_id = SSP_CODEC; + else { + dev_dbg(dai->dev, "port %s is not supported\n", id); + return -1; + } + SST_FILL_DEFAULT_DESTINATION(drv->ssp_cmd.header.dst); drv->ssp_cmd.header.command_id = SBA_HW_SET_SSP; drv->ssp_cmd.header.length = sizeof(struct sst_cmd_sba_hw_set_ssp) - sizeof(struct sst_dsp_header);
- config = &sst_ssp_configs; - dev_dbg(dai->dev, "ssp_id: %u\n", config->ssp_id); + drv->ssp_cmd.selection = ssp_id; + dev_dbg(dai->dev, "ssp_id: %u\n", ssp_id);
if (enable) drv->ssp_cmd.switch_state = SST_SWITCH_ON;