Andy Shevchenko andy.shevchenko@gmail.com writes:
On Mon, Jun 20, 2022 at 10:08 PM Aidan MacDonald aidanmacdonald.0x0@gmail.com wrote:
No drivers currently use mask_writeonly, and in its current form it seems a bit misleading. When set, mask registers will be updated with regmap_write_bits() instead of regmap_update_bits(), but regmap_write_bits() still does a read-modify-write under the hood. It's not a write-only operation.
Performing a simple regmap_write() is probably more useful, since it can be used for chips that have separate set & clear registers for controlling mask bits. Such registers are normally volatile and read as 0, so avoiding a register read minimizes bus traffic.
Reading your explanations and the code, I would rather think about fixing the regmap_write_bits() to be writeonly op.
That's impossible without special hardware support.
Otherwise it's unclear what's the difference between regmap_write_bits() vs. regmap_update_bits().
This was not obvious to me either. They're the same except in how they issue the low-level write op -- regmap_update_bits() will only do the write if the new value differs from the current one. regmap_write_bits() will always do a write, even if the new value is the same.
I think the problem is lack of documentation. I only figured this out by reading the implementation.
if (d->chip->mask_writeonly)
return regmap_write_bits(d->map, reg, mask, val);
return regmap_write(d->map, reg, val & mask); else return regmap_update_bits(d->map, reg, mask, val);