-----Original Message----- From: Takashi Iwai [mailto:tiwai@suse.de] Sent: Thursday, December 17, 2015 3:44 PM To: Zhang, Xiong Y Cc: alsa-devel@alsa-project.org; Yang, Libin; Lu, Han Subject: Re: [alsa-devel] [PATCH] ALSA: hda - Set intel hda controller power at freeze() and thaw()
On Thu, 17 Dec 2015 07:58:44 +0100, Xiong Zhang wrote:
It takes three minutes to enter into hibernation on some OEM SKL machines and we see many codec spurious response after thaw()
opertion.
This is because HDA is still in D0 state after freeze() call and pci_pm_freeze/pci_pm_freeze_noirq() don't set D3 hot in pci_bus
driver.
It seems bios still access HDA when system enter into freeze state, HDA will receive codec response interrupt immediately after thaw() call. Because of this unexpected interrupt, HDA enter into a abnormal state and slow down the system enter into hibernation.
In this patch, we put HDA into D3 hot state in azx_freeze_noirq() and put HDA into D0 state in azx_thaw_noirq().
A slight concern is whether this would cause any impact on older chipsets. I don't believe it would, but BIOSen are often crazy sensitive about such a detail.
Maybe safer to limit this to SKL+? I guess Broxton should be covered as well?
As the issue fixed by the patch is only found on SKL, I agree to limit it to SKL+. And apply it to other old platforms later if necessary.
BTW: We have tested it on BDW and SKL. It works on both platforms.
Regards, Libin
thanks,
Takashi
Signed-off-by: Xiong Zhang xiong.y.zhang@intel.com
sound/pci/hda/hda_intel.c | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+)
diff --git a/sound/pci/hda/hda_intel.c b/sound/pci/hda/hda_intel.c index c38c68f..3ba7cbc 100644 --- a/sound/pci/hda/hda_intel.c +++ b/sound/pci/hda/hda_intel.c @@ -890,6 +890,16 @@ static int azx_suspend(struct device *dev) return 0; }
+static int azx_freeze_noirq(struct device *dev) +{
- struct pci_dev *pci = to_pci_dev(dev);
- if (pci->vendor == PCI_VENDOR_ID_INTEL)
pci_set_power_state(pci, PCI_D3hot);- return 0;
+}
static int azx_resume(struct device *dev) { struct pci_dev *pci = to_pci_dev(dev); @@ -924,6 +934,14 @@ static int azx_resume(struct device *dev) trace_azx_resume(chip); return 0; }
+static int azx_thaw_noirq(struct device *dev) +{
- struct pci_dev *pci = to_pci_dev(dev);
- if (pci->vendor == PCI_VENDOR_ID_INTEL)
pci_set_power_state(pci, PCI_D0);+} #endif /* CONFIG_PM_SLEEP || SUPPORT_VGA_SWITCHEROO */
#ifdef CONFIG_PM @@ -1035,6 +1053,8 @@ static int azx_runtime_idle(struct device
*dev)
static const struct dev_pm_ops azx_pm = { SET_SYSTEM_SLEEP_PM_OPS(azx_suspend, azx_resume)
- .freeze_noirq = azx_freeze_noirq,
- .thaw_noirq = azx_thaw_noirq, SET_RUNTIME_PM_OPS(azx_runtime_suspend,
azx_runtime_resume, azx_runtime_idle)
};
-- 1.8.2.1
Alsa-devel mailing list Alsa-devel@alsa-project.org http://mailman.alsa-project.org/mailman/listinfo/alsa-devel