Just powering on, these devices below wait to download firmware. - Firewire Audiophile - Firewire 410 - Firewire 1814 - ProjectMix I/O
But firmware version 5058 or later, flash memory in the device stores the firmware. So this driver can enable these devices by sending a certain cue to load the firmware.
Signed-off-by: Takashi Sakamoto o-takashi@sakamocchi.jp --- sound/firewire/bebob/bebob.c | 23 +++++++------ sound/firewire/bebob/bebob.h | 1 + sound/firewire/bebob/bebob_maudio.c | 64 +++++++++++++++++++++++++++++++++++++ 3 files changed, 79 insertions(+), 9 deletions(-)
diff --git a/sound/firewire/bebob/bebob.c b/sound/firewire/bebob/bebob.c index ffb042b..e1dd421 100644 --- a/sound/firewire/bebob/bebob.c +++ b/sound/firewire/bebob/bebob.c @@ -177,18 +177,21 @@ bebob_probe(struct fw_unit *unit, }
if ((entry->vendor_id == VEN_FOCUSRITE) && - (entry->model_id == MODEL_FOCUSRITE_SAFFIRE_BOTH)) { + (entry->model_id == MODEL_FOCUSRITE_SAFFIRE_BOTH)) spec = get_saffire_spec(unit); - } else if ((entry->vendor_id == VEN_MAUDIO1) && - (entry->model_id == MODEL_MAUDIO_AUDIOPHILE_BOTH) && - !check_audiophile_booted(unit)) { - err = 0; - goto end; - } else { + else if ((entry->vendor_id == VEN_MAUDIO1) && + (entry->model_id == MODEL_MAUDIO_AUDIOPHILE_BOTH) && + !check_audiophile_booted(unit)) + spec = NULL; + else spec = (const struct snd_bebob_spec *)entry->driver_data; - } + if (spec == NULL) { - err = -ENOSYS; + if ((entry->vendor_id == VEN_MAUDIO1) || + (entry->vendor_id == VEN_MAUDIO2)) + err = snd_bebob_maudio_load_firmware(unit); + else + err = -ENOSYS; goto end; }
@@ -374,6 +377,7 @@ static const struct ieee1394_device_id bebob_id_table[] = { SND_BEBOB_DEV_ENTRY(VEN_FOCUSRITE, MODEL_FOCUSRITE_SAFFIRE_BOTH, &saffire_spec), /* M-Audio, Firewire 410 */ + SND_BEBOB_DEV_ENTRY(VEN_MAUDIO2, 0x00010058, NULL), /* bootloader */ SND_BEBOB_DEV_ENTRY(VEN_MAUDIO2, 0x00010046, &maudio_fw410_spec), /* M-Audio, Firewire Audiophile */ SND_BEBOB_DEV_ENTRY(VEN_MAUDIO1, MODEL_MAUDIO_AUDIOPHILE_BOTH, @@ -387,6 +391,7 @@ static const struct ieee1394_device_id bebob_id_table[] = { /* M-Audio, ProFireLightbridge */ SND_BEBOB_DEV_ENTRY(VEN_MAUDIO1, 0x000100a1, &spec_normal), /* Firewire 1814 */ + SND_BEBOB_DEV_ENTRY(VEN_MAUDIO1, 0x00010070, NULL), /* bootloader */ SND_BEBOB_DEV_ENTRY(VEN_MAUDIO1, MODEL_MAUDIO_FW1814, &maudio_special_spec), /* M-Audio ProjectMix */ diff --git a/sound/firewire/bebob/bebob.h b/sound/firewire/bebob/bebob.h index eba0129..4a54e74 100644 --- a/sound/firewire/bebob/bebob.h +++ b/sound/firewire/bebob/bebob.h @@ -242,6 +242,7 @@ extern struct snd_bebob_spec maudio_ozonic_spec; extern struct snd_bebob_spec maudio_nrv10_spec; extern struct snd_bebob_spec maudio_special_spec; int snd_bebob_maudio_special_discover(struct snd_bebob *bebob, bool is1814); +int snd_bebob_maudio_load_firmware(struct fw_unit *unit);
#define SND_BEBOB_DEV_ENTRY(vendor, model, data) \ { \ diff --git a/sound/firewire/bebob/bebob_maudio.c b/sound/firewire/bebob/bebob_maudio.c index 544094b..52b1a40 100644 --- a/sound/firewire/bebob/bebob_maudio.c +++ b/sound/firewire/bebob/bebob_maudio.c @@ -16,6 +16,10 @@ * settings when completing uploading. Then these devices generate bus reset * and are recognized as new devices with the firmware. * + * But with firmware version 5058 or later, the firmware is stored to flash + * memory in the device and drivers can tell bootloader to load the firmware + * by sending a cue. This cue must be sent one time. + * * For streaming, both of output and input streams are needed for Firewire 410 * and Ozonic. The single stream is OK for the other devices even if the clock * source is not SYT-Match (I note no devices use SYT-Match). @@ -31,6 +35,20 @@ * functionality is between 0xffc700700000 to 0xffc70070009c. */
+/* Offset from information register */ +#define INFO_OFFSET_SW_DATE 0x20 + +/* Bootloader Protocol Version 1 */ +#define MAUDIO_BOOTLOADER_CUE1 0x00000001 +/* + * Initializing configuration to factory settings (= 0x1101), (swapped in line), + * Command code is zero (= 0x00), + * the number of operands is zero (= 0x00)(at least significant byte) + */ +#define MAUDIO_BOOTLOADER_CUE2 0x01110000 +/* padding */ +#define MAUDIO_BOOTLOADER_CUE3 0x00000000 + #define MAUDIO_SPECIFIC_ADDRESS 0xffc700000000
#define METER_OFFSET 0x00600000 @@ -67,6 +85,52 @@ struct special_params { struct snd_ctl_elem_id *ctl_id_sync; };
+/* + * For some M-Audio devices, this module just send cue to load firmware. After + * loading, the device generates bus reset and newly detected. + * + * If we make any transactions to load firmware, the operation may failed. + */ +int snd_bebob_maudio_load_firmware(struct fw_unit *unit) +{ + struct fw_device *device = fw_parent_device(unit); + int err, rcode; + u64 date; + __be32 cues[3] = { + MAUDIO_BOOTLOADER_CUE1, + MAUDIO_BOOTLOADER_CUE2, + MAUDIO_BOOTLOADER_CUE3 + }; + + /* check date of software used to build */ + err = snd_bebob_read_block(unit, INFO_OFFSET_SW_DATE, + &date, sizeof(u64)); + if (err < 0) + goto end; + /* + * firmware version 5058 or later has date later than "20070401", but + * 'date' is not null-terminated. + */ + if (date < 0x3230303730343031) { + dev_err(&unit->device, + "Use firmware version 5058 or later\n"); + err = -ENOSYS; + goto end; + } + + rcode = fw_run_transaction(device->card, TCODE_WRITE_BLOCK_REQUEST, + device->node_id, device->generation, + device->max_speed, BEBOB_ADDR_REG_REQ, + cues, sizeof(cues)); + if (rcode != RCODE_COMPLETE) { + dev_err(&unit->device, + "Failed to send a cue to load firmware\n"); + err = -EIO; + } +end: + return err; +} + static inline int get_meter(struct snd_bebob *bebob, void *buf, unsigned int size) {