14 Nov
2018
14 Nov
'18
10:31 a.m.
On Tue, Nov 13, 2018 at 12:49:17PM -0600, James Schulman wrote:
Add device tree documentation for Cirrus Logic CS35L36 speaker amplifier
Signed-off-by: James Schulman james.schulman@cirrus.com
+Optional properties:
- cirrus,sclk-force-output : Audio serial port SCLK force
- output control. Forces the SCLK to continue to drive even
- if no ASP_TXn channels are enabled.
- cirrus,lrclk-force-output : Audio serial port LRCLK force
- output control. Forces the LRCLK to continue to drive even
- if no ASP_TXn channels are enabled.
Would it be best to use SND_SOC_DAIFMT_CONT/GATED for these? Unless I have misunderstood their purpose, although presently that doesn't give you individual control over sclk and lrclk.
+Example:
+cs35l36: cs35l36@40 {
- compatible = "cirrus,cs35l36";
- reg = <0x40>;
- VA-supply = <&dummy_vreg>;
- VP-supply = <&dummy_vreg>;
- reset-gpios = <&gpio0 54 0>;
- interrupt-parent = <&gpio8>;
- interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
- cirrus,boost-ind-nanohenry = <1000>;
- cirrus,boost-ctl-millivolt = <10000>;
- cirrus,boost-ctl-select = <0x00>;
- cirrus,boost-peak-milliamp = <4500>;
- cirrus,amp-gain-zc;
- cirrus,ldm-mode-select = <0x01>;
- cirrus,pdm-ldm-exit;
- cirrus,pdm-ldm-enter;
- cirrus,weak-fet-delay = <0x04>;
- cirrus,weak-fet-thld = <0x01>;
- cirrus,temp-warn-threshold = <0x01>;
- cirrus,multi-amp-mode;
- cirrus,vpbr-config {
cirrus,vpbr-en = <0x00>;cirrus,vpbr-thld = <0x05>;cirrus,vpbr-atk-rate = <0x02>;cirrus,vpbr-atk-vol = <0x01>;cirrus,vpbr-max-attn = <0x09>;cirrus,vpbr-wait = <0x01>;cirrus,vpbr-rel-rate = <0x05>;cirrus,vpbr-mute-en = <0x00>;- };
- cirrus,irq-config {
cirrus,irq-drive-select = <0x01>;cirrus,irq-polarity = <0x00>;cirrus,irq-gpio-select = <0x01>;cirrus,irq-output-enable = <0x01>;cirrus,irq-src-select = <0x01>;- };
This block is not documented in the rest of the document and looks like things that should really be controlled through other means. Presuming this is legacy and just needs removed?
Thanks, Charles