9 Jun
2015
9 Jun
'15
7:07 p.m.
On Tue, Jun 09, 2015 at 01:59:36PM +0100, Srinivas Kandagatla wrote:
- if (cpu_dai->id == MI2S_QUATERNARY) {
/* Configure the Quat MI2S to TLMM */writel(readl(pdata->mic_iomux) |MIC_CTRL_QUA_WS_SLAVE_SEL_10 |MIC_CTRL_TLMM_SCLK_EN,pdata->mic_iomux);return 0;- } else if (cpu_dai->id == MI2S_PRIMARY) {
writel(readl(pdata->spkr_iomux) |SPKR_CTL_PRI_WS_SLAVE_SEL_11,pdata->spkr_iomux);return 0;- }
Why not just do these one time at probe, we don't undo them when we shut the DAI down?
- dev_err(card->dev, "unsupported cpu dai configuration\n");
- return -EINVAL;
It'd be clearer if this were part of the above code (which should still be written as a switch statement) - I was just asking myself what happens if we fall off the end of the if/else chain.
/*** External codec is ADV7533* and internal codec digital part is inside apq8016* and analog part is in PMIC PM8916**/if (of_property_read_bool(np, "external"))name = "ADV7533";elsename = "WCD";
If this is all the property is doing why not just put a link name property in the DT rather than this? That makes the driver a bit more general and is more idiomatic.
dai_link->name = dai_link->stream_name = name;
Write two assignment statements, it's clearer and more idiomatic.