Hello.
On 10/15/10 07:08, vm.rod25@gmail.com wrote:
From: Victor Rodriguezvictor.rodriguez@sasken.com
This patch adds EMAC support for the Hawkboard-L138 system
Signed-off-by: Victor Rodriguezvictor.rodriguez@sasken.com
arch/arm/mach-davinci/board-omapl138-hawk.c | 50 +++++++++++++++++++++++++++ 1 files changed, 50 insertions(+), 0 deletions(-)
diff --git a/arch/arm/mach-davinci/board-omapl138-hawk.c b/arch/arm/mach-davinci/board-omapl138-hawk.c index c472dd8..2220105 100644 --- a/arch/arm/mach-davinci/board-omapl138-hawk.c +++ b/arch/arm/mach-davinci/board-omapl138-hawk.c @@ -19,6 +19,54 @@
#include<mach/cp_intc.h> #include<mach/da8xx.h> +#include<mach/mux.h>
+#define HAWKBOARD_PHY_ID "0:07"
+static short omapl138_hawk_mii_pins[] __initdata = {
- DA850_MII_TXEN, DA850_MII_TXCLK, DA850_MII_COL, DA850_MII_TXD_3,
- DA850_MII_TXD_2, DA850_MII_TXD_1, DA850_MII_TXD_0, DA850_MII_RXER,
- DA850_MII_CRS, DA850_MII_RXCLK, DA850_MII_RXDV, DA850_MII_RXD_3,
- DA850_MII_RXD_2, DA850_MII_RXD_1, DA850_MII_RXD_0, DA850_MDIO_CLK,
- DA850_MDIO_D,
- -1
+};
+static __init void omapl138_hawk_config_emac(void) +{
- void __iomem *cfgchip3;
- int ret;
- u32 val;
- struct davinci_soc_info *soc_info =&davinci_soc_info;
- if (!machine_is_omapl138_hawkboard())
return;
- cfgchip3 = DA8XX_SYSCFG0_VIRT(DA8XX_CFGCHIP3_REG);
- val = __raw_readl(cfgchip3);
- val&= ~BIT(8);
- ret = davinci_cfg_reg_list(omapl138_hawk_mii_pins);
- if (ret) {
pr_warning("%s: "
"cpgmac/mii mux setup failed: %d\n", __func__, ret);
return;
- }
- pr_info("EMAC: MII PHY configured\n");
I said this should *follow* __raw_writel(), not precede it...
- /* configure the CFGCHIP3 register for MII */
- __raw_writel(val, cfgchip3);
- soc_info->emac_pdata->phy_id = HAWKBOARD_PHY_ID;
- ret = da8xx_register_emac();
- if (ret)
pr_warning("%s: "
"emac registration failed: %d\n", __func__, ret);
return;
'return' not needed here. And you've forgotten to enclose it in {} anyway. :-)
WBR. Sergei