On Tuesday, July 28, 2015 03:19:31 PM Tomeu Vizoso wrote:
Hello,
I have a problem with the panel on my Tegra Chromebook taking longer than expected to be ready during boot (Stéphane Marchesin reported what is basically the same issue in [0]), and have looked into ordered probing as a better way of solving this than moving nodes around in the DT or playing with initcall levels and linking order.
While reading the thread [1] that Alexander Holler started with his series to make probing order deterministic, it occurred to me that it should be possible to achieve the same by probing devices as they are referenced by other devices.
This basically reuses the information that is already implicit in the probe() implementations, saving us from refactoring existing drivers or adding information to DTBs.
During review of v1 of this series Linus Walleij suggested that it should be the device driver core to make sure that dependencies are ready before probing a device. I gave this idea a try [2] but Mark Brown pointed out to the logic duplication between the resource acquisition and dependency discovery code paths (though I think it's fairly minor).
To address that code duplication I experimented with Arnd's devm_probe [3] concept of having drivers declare their dependencies instead of acquiring them during probe, and while it worked [4], I don't think we end up winning anything when compared to just probing devices on-demand from resource getters.
One remaining objection is to the "sprinkling" of calls to fwnode_ensure_device() in the resource getters of each subsystem, but I think it's the right thing to do given that the storage of resources is currently subsystem-specific.
We could avoid the above by moving resource storage into the core, but I don't think there's a compelling case for that.
I have tested this on boards with Tegra, iMX.6, Exynos and OMAP SoCs, and these patches were enough to eliminate all the deferred probes (except one in PandaBoard because omap_dma_system doesn't have a firmware node as of yet).
With this series I get the kernel to output to the panel in 0.5s, instead of 2.8s.
Can you trim your CC list somewhat, please?
I'm definitely going to look at this, but not before then next week. Sorry about that.
Thanks, Rafael