Hi Mark: Thanks for your review.
On 2021/1/13 1:54, Mark Brown wrote:
On Wed, Jan 13, 2021 at 01:18:14AM +0800, Perry Yuan wrote:
Some new Dell system is going to support audio internal micphone privacy setting from hardware level with micmute led state changing When micmute hotkey pressed by user, soft mute will need to be enabled firstly in case of pop noise, and codec driver need to react to mic mute event to EC(embedded controller) notifying that SW mute is completed Then EC will do the hardware mute physically within the timeout reached
This patch allow codec rt715 driver to ack EC when micmute key pressed through this micphone led control interface like hda_generic provided ACPI method defined in dell-privacy micmute led trigger will be called for notifying the EC that software mute has been completed
It feels like there's an abstraction problem here with this being hard coded in a specific CODEC driver.
#include <linux/soundwire/sdw.h> @@ -244,6 +245,7 @@ static int rt715_sdca_get_volsw(struct snd_kcontrol *kcontrol, unsigned int max = mc->max; int val;
- pr_err("++++++rt715_sdca_get_volsw++\n"); val = snd_soc_component_read(component, mc->reg); if (val < 0) return -EINVAL;
This shouldn't be in the patch.
Removed in V4, I forget to clear this debug code
@@ -287,6 +291,18 @@ static int rt715_sdca_put_volsw(struct snd_kcontrol *kcontrol, return err; }
+#if IS_ENABLED(CONFIG_DELL_PRIVACY)
- /* dell privacy LED trigger state changed by muted/unmute switch */
- if (mc->invert) {
if (ucontrol->value.integer.value[0] || ucontrol->value.integer.value[1]) {rt715->micmute_led = LED_OFF;} else {rt715->micmute_led = LED_ON;}ledtrig_audio_set(LED_AUDIO_MICMUTE, rt715->micmute_led);- }
+#endif
This doesn't look good. There's nothing Dell specific here, and nothing about this is conditional on any sort of runtime detection of Dell systems, it's not obvious why this is conditional on DELL_PRIVACY or why we only report the state if the control is inverted.
I will remove the CONFIG_DELL_PRIVACY from V4 patch and allow it to run if CONFIG_DELL_PRIVACY is not set, the result will be a no-op.
I'm also not convinced that it's a good idea to set the mute LED if only one channel in a stereo microphone is muted, that seems likely to lead to surprising behaviour for users.
https://github.com/thesofproject/linux/pull/2660#discussion_r555480210 There is a discussion for the channel mute changing behavior. If the anyone of value[0] or value[1] is 1, it means mic is NOT muted The muted state will be LED_ON state need to set.
TBH I don't understand why this isn't being done in generic code.
- bool micmute_led;
What is this for, it never seems to be read except for in the function where it's set?
I have moved this part code to the local definition of rt715_set_amp_gain_put and removed from rt715_priv. new code will be like this in V4.
@@ -88,6 +89,7 @@ static int rt715_set_amp_gain_put(struct snd_kcontrol *kcontrol, RT715_SET_GAIN_MIX_ADC2_L}; unsigned int addr_h, addr_l, val_h, val_ll, val_lr; unsigned int read_ll, read_rl, i, j, loop_cnt; + bool micmute_led;