On Tue, May 12, 2009 at 12:00:33AM +0200, Karl Beldan wrote:
Then it is perfectly normal since reset enables both REC and RPL, 2/4 needs 1/4. The current tree disables the clocks anytime one function is disabled.
That doesn't seem to tie up - I can see the initialisation changing the behaviour on first run but it seems surprising that this should happen on subsequent runs too. Alternatively, is your initialisation patch safe to apply by itself?
I resent 1/4 and will make it 1/5 with the whole serie once everything is Clear.
As previously discussed you need to rework the patch to not do the reset on initial probe not when the module is loaded, you need to address this rather than reposting.
I'll try to find time to re-review the series but I'm going to need to sit down with the datasheet and check this in much more detail.