Hello,
I try to get working an AKM4556 codec on the arm64 Rockchip RK3399 board under Linux 4.4.179 The codec is a simple one (without i2c connection), similar to AKM4554 (but 24 bit instead of 16 bit audio) and hard configured to use i2s. I implemented the driver soc/codecs/ak4556.c which has only few differences to ak4554.c. But when I try to get it working with the soc/general/simple-card.c, the connection to the codec fails Both drivers (snd_soc_simple_card and snd_soc_ak4556) get loaded, the call to
asoc_simple_card_dai_link_of -> asoc_simple_card_sub_parse_of(cpu, ..)
is OK, but the call to
asoc_simple_card_dai_link_of -> asoc_simple_card_sub_parse_of(codec, ..) -> snd_soc_of_get_dai_name
fails with -EPROBE_DEFER.
Now, i am not sure if it is a driver issue or rather a device-tree one. I declared dt like this :
/ {
ak4556_card: ak4556-adc-dac { status = "okay"; compatible = "simple-audio-card";
simple-audio-card,name = "ak4556"; simple-audio-card,format = "i2s"; simple-audio-card,mclk-fs = <256>;
simple-audio-card,widgets = "Line", "Line In", "Line", "Line Out"; simple-audio-card,routing = "LIN", "Line In", "RIN", "Line In", "Line Out", "LOUT", "Line Out", "ROUT";
simple-audio-card,cpu { sound-dai = <&i2s0>; }; simple-audio-card,codec { sound-dai = <&ak4556_codec>; }; };
ak4556_codec: ak4556-codec { status = "okay"; compatible = "asahi-kasei,ak4556"; #sound-dai-cells = <0>; };
i2s0: i2s@ff880000 {
compatible = "rockchip,rk3399-i2s", "rockchip,rk3066-i2s"; reg = <0x0 0xff880000 0x0 0x1000>; rockchip,grf = <&grf>; interrupts = <GIC_SPI 39 IRQ_TYPE_LEVEL_HIGH 0>; dmas = <&dmac_bus 0>, <&dmac_bus 1>; dma-names = "tx", "rx"; clock-names = "i2s_clk", "i2s_hclk"; clocks = <&cru SCLK_I2S0_8CH>, <&cru HCLK_I2S0_8CH>; resets = <&cru SRST_I2S0_8CH>, <&cru SRST_H_I2S0_8CH>; reset-names = "reset-m", "reset-h"; pinctrl-names = "default"; pinctrl-0 = <&i2s0_8ch_bus>; power-domains = <&power RK3399_PD_SDIOAUDIO>; status = "disabled"; };
&i2s0 { #sound-dai-cells = <0>; assigned-clocks = <&cru SCLK_I2S0_DIV>; assigned-clock-parents = <&cru PLL_GPLL>; status = "okay"; };
Thank you in advance for your suggestions,
Markus