On 09/12/2014 06:04 AM, Anatol Pomozov wrote:
Hi
I bringing up a board that has Realtek 5677 codec. The codec has 6 gpios and two of them are used by the board. pin3 is used to enable headphones amplifier. pin2 is used to gate DMIC clock for 3 of 4 DMICs
- it allows to leave only one DMIC working in low-power mode.
Now I need to configure the codec that when "Headphones" audio path is enabled then pin3 should go high. The same true for DMIC/pin2. I was looking for existing similar solutions but cannot find one.
I need something similar to SND_SOC_DAPM_REGULATOR_SUPPLY that allows to turn on/off part of the system. But instead of manipulating a voltage regulator I just need to set/unset codec's gpio. What would be the best way to achieve it?
You can "convert" gpios to supply regulators using a "fixed" regulator driver (instantiated in the devicetree, or platform code on older kernels).
The problem here is that codec does not know which of the outputs (LOUT1, LOUT2, LOUT3) corresponds to headphones. It is configured as audio path in *.dts file. _______________________________________________ Alsa-devel mailing list Alsa-devel@alsa-project.org http://mailman.alsa-project.org/mailman/listinfo/alsa-devel