On 29/09/2021 10:43, Sameer Pujar wrote:
On 9/29/2021 2:55 AM, Pierre-Louis Bossart wrote:
On 8/27/21 4:33 AM, Sameer Pujar wrote:
[...]
But in addition we'd need to agree on what an 'active BE' is. Why can't we connect a second stream while the first one is already in HW_PARAMS or PAUSED or STOP? It's perfectly legal in ALSA/ASoC to have multiple HW_PARAMS calls, and when we reach STOP we have to do a prepare again.
And more fundamentally, the ability to add a second FE on a 'active' BE in START state is a basic requirement for a mixer, e.g. to play a notification on one FE while listening to music on another. What needs to happen is only to make sure that the FE and BE are compatible in terms of HW_PARAMS and not sending a second TRIGGER_STOP, only checking the BE NEW or CLOSE state is way too restrictive.
Sorry for the trouble to your system.
Idea was to avoid reconfiguration of the same BE DAI again, but not to stop the provision to add a subsequent FE. In fact I had tested mixing of streams coming from 10 different FEs.
In your case, because of this patch, looks like the subsequent FE is not finding a BE DAI since it is already active due to a prior FE. The reason it works at my end is because the mixer input and output DAIs are separated. Any new FE would just configure the mixer input DAI to which it is attached and skip already running/configured output DAI.
The problem as I see is that with this patch one can not connect a new FE to a BE which is _not_ in NEW or CLOSE state.
The FE and BE needs to be connected to have DPCM working and this patch makes the code to skip the dpcm_be_connect().
Consider this simple setup:
FE1 -->| | --> BE --> FE2- ->|
First we start FE1, dpcm_be_connect(FE1, BE, stream) is made.
Later FE2 is started but dpcm_be_connect(FE2, BE, stream) would be not made because BE is no longer in NEW/CLOSE state.
I am just curious to know, if originally you were reconfiguring the BE DAI again with same parameters (for a second FE) or some additional configuration is done?
I can send a revert with the explanations in the commit message if there is a consensus that this patch needs to be revisited.
May be this can be revisited since it appears to be a critical problem for your system. But I hope this discussion can be alive on following points for a better fix.
- The original issue at my end was not just a configuration redundancy.
I realize now that with more stream addition following error print is seen. "ASoC: too many users playback at open 4"
This is because the max DPCM users is capped at 8. Increasing this may help (need to see what number is better), but does not address the redundancy problem.
- If reconfiguration of the same BE is not necessary for a subsequent
FE run, shouldn't we avoid the reconfig itself and somehow avoid FE failure?
I'm not sure, but it might be possible to just skip the dpcm_set_be_update_state(be, stream, SND_SOC_DPCM_UPDATE_BE); call at the end of the loop, but the question is under which condition? Can a BE asked to be reconfigured when STOP/OPEN/HW_PARAMS?
Skipping the connect does not sound right for a new FE-BE connection.