Hi Brian, I've been thinking of doing something sort of similar, but perhaps different. It looks like you plan to go I2S/TDM into the McSPI, correct? I've done this with a microcontroller before, which works mostly. The problem is that since the SPI port doesn't know about the frame sync signal, any ESD strike that comes along provides an extra clock, and your entire bit-stream gets out of sync. So, as long as you can protect from ESD well, it will work at the hardware level.
I've been thinking about using an interposer microcontroller that will convert I2S to a packetized SPI protocol, so I can have any number of codec channels, up to the limit of the SPI speed. I'm not sure how it will all work though (you can see my previous email on the subject).
Anyway, I'm definitely interested to hear how things are progressing.
-Caleb
On Fri, Oct 9, 2015 at 7:29 AM, Brian Clarkson < clarkson@orthogonaldevices.com> wrote:
Hi
I'm about to embark on the development of an ASoC capture driver that uses SPI to stream the samples to the processor. I'm still spending a lot of my time going through the ALSA kernel code but as I do that may I have some suggestions as to which examples would be closest to my case? My development hardware is AM335x --> McSPI --> ADS8868.
So far I think I have achieved a solid understanding of the "simple-card" case where you have dai-link that connects a processor peripheral driver (e.g. McASP ) with a codec driver and forms a snd_soc_card that can be registered. Is my best option to:
- write a new CPU DAI (snd_soc_dai_driver) based on the existing SPI driver
- write a new CODEC DAI (snd_soc_dai_driver) which will be mostly empty
- write a new platform driver that populates and registers a new
snd_soc_card struct with the above in a dai_link?
Any advice would be much appreciated.
Cheers, Brian
-- Orthogonal Devices Tokyo, Japan www.orthogonaldevices.com +81 80 8700 2340
Alsa-devel mailing list Alsa-devel@alsa-project.org http://mailman.alsa-project.org/mailman/listinfo/alsa-devel