Takashi Iwai wrote:
At Wed, 15 Apr 2009 10:45:43 -0400, Jerry Geis wrote:
Takashi Iwai wrote:
At Wed, 15 Apr 2009 10:00:33 -0400, Jerry Geis wrote:
I am using the gigabyte MA78GM-US2H motherboard. it has the ALC889A audio.
I am trying 1.0.19 and audio works out the analog back port but not over HDMI.
Never mind about "Function ID" entry. It's just a new line that was added recently. function_id=1 means it's an audio codec.
The way HDMI is supported are mainly either through the same audio codec (ALC889A) or through a dedicated HDMI codec. In the former case, you'll likely see a word "HDMI" in the digital output pin of the codec proc file. In the latter case, you must have a different codec chip connected to the HD-audio bus with a different codec address number.
Takashi
Codec: Realtek ALC889A Address: 0 Function Id: 0x1 <--------------------------------- this is different Vendor Id: 0x10ec0885 Subsystem Id: 0x1458a002 Revision Id: 0x100101 No Modem Function Group found Default PCM: rates [0x560]: 44100 48000 96000 192000 bits [0xe]: 16 20 24 formats [0x1]: PCM Default Amp-In caps: N/A Default Amp-Out caps: N/A GPIO: io=2, o=0, i=0, unsolicited=1, wake=0 IO[0]: enable=0, dir=0, wake=0, sticky=0, data=0, unsol=0 IO[1]: enable=0, dir=0, wake=0, sticky=0, data=0, unsol=0 Node 0x02 [Audio Output] wcaps 0x11: Stereo Converter: stream=0, channel=0 PCM: rates [0x560]: 44100 48000 96000 192000 bits [0xe]: 16 20 24 formats [0x1]: PCM Node 0x03 [Audio Output] wcaps 0x11: Stereo
I have been looking but havent found a solution yet. I tried grabbing the snapshot tar ball for today but I get errors on the compile.
I had a similiar motherboard but it does not report Function ID: 01 : - HDMI audio on this board works correctly. Codec: Realtek ALC889A Address: 0 Vendor Id: 0x10ec0885 Subsystem Id: 0x1458a002 Revision Id: 0x100101 No Modem Function Group found Default PCM: rates [0x560]: 44100 48000 96000 192000
Any thoughts????
Jerry _______________________________________________ Alsa-devel mailing list Alsa-devel@alsa-project.org http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
I upload alsa-info.sh
for the NOT WORKIng one http://www.alsa-project.org/db/?f=7e8bc9485e8bb98bf15dae5a0d5dc038003c3203
for the working on http://www.alsa-project.org/db/?f=a18bcb6e87fe33a7365a749d0877a4546e901bf2
How are you testing HDMI output?
Takashi
I have a sharp aquos HDMI that works with the other motherboard.
I am just switching between the two.
I have the asound.conf set to the correct hw:X,y on both machines for HDMI.
Jerry