On Fri, Dec 21, 2012 at 09:19:20AM +0800, Axel Lin wrote:
The mode variable is either 0 or 1. To update mode setting, the mask should be BIT(0) rather than BIT(1).
Signed-off-by: Axel Lin axel.lin@ingics.com
Hi M R Swami, I don't have the datasheet. Can you check if this patch is correct?
Yes, according to the datasheet the STEREO mode is BIT(0).
Thanks, Axel sound/soc/codecs/lm49453.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/sound/soc/codecs/lm49453.c b/sound/soc/codecs/lm49453.c index d75257d..c0d203b 100644 --- a/sound/soc/codecs/lm49453.c +++ b/sound/soc/codecs/lm49453.c @@ -1218,7 +1218,7 @@ static int lm49453_set_dai_fmt(struct snd_soc_dai *codec_dai, unsigned int fmt) }
snd_soc_update_bits(codec, LM49453_P0_AUDIO_PORT1_BASIC_REG,
LM49453_AUDIO_PORT1_BASIC_FMT_MASK|BIT(1)|BIT(5),
LM49453_AUDIO_PORT1_BASIC_FMT_MASK|BIT(0)|BIT(5), (aif_val | mode | clk_phase));snd_soc_write(codec, LM49453_P0_AUDIO_PORT1_RX_MSB_REG, clk_shift);
-- 1.7.9.5
Alsa-devel mailing list Alsa-devel@alsa-project.org http://mailman.alsa-project.org/mailman/listinfo/alsa-devel