From: Jeeja KP jeeja.kp@intel.com
This patch series includes driver updates for the handling scenarios during System S0/S3 transitions when audio stream is stopped during system. o move DMA configuration in DSP Gateway Module widget event handler to ensure DMA is configured after resume. o Enable SSP MLCK using Supply widget. This will ensure the MCLK is enabled when the widget is power on. o Check DMA decouple register state before coupling/decoupling the DMA. o In case of HDMI pass-through pipe, reset only the FE Pipe when stream in in XRUN state. o Resume the stream from HW renderer position. o HDMI Codec pin and converter state need to be restored when stream is resumed.
Changes in v2: - Addressed Mark's comment on patch 1, split this into 2 as this had additional changes other than configuring the DMA. - Addressed Takashi's comment on the usage of snd_hdac_updatel()
Changes in v3: - Addressed Takashi's comment on superfluous shift used in reading the value of PPCTL register and also cleaned the condition for updating the reg value.
Changes in v4: - Acked by Takashi for patch "ALSA: hda: check stream decoupled register state". - Removed compilation warning in patch "ASoC: hdac_hdmi: Enable pin and converter in prepare". - Remove 4 patches which are already applied.
Changes in v5: - Removed the SSP MCLK patchs from this series, will rework and posted later based on Marks' comments.
Jeeja KP (3): ASoC: Intel: Skylake: Don't reset pass-through pipe in BE prepare ASoC: Intel: Skylake: set the resume point to LPIB ASoC: hdac_hdmi: Enable pin and converter in prepare
sound/soc/codecs/hdac_hdmi.c | 37 +++++++++++++++++-------------------- sound/soc/intel/skylake/skl-pcm.c | 6 +++--- 2 files changed, 20 insertions(+), 23 deletions(-)