Hello, I have found that output volume is set to the default value after a limited time (~4 seconds) after play stop. I have analyzed what is happening: - at first play the volume is the expected one - After stopping playing + ~4 seconds wm8904_set_bias_level (..., SND_SOC_BIAS_OFF) is called - Chip is reset and regulator is switched off if "possible" (not in our case, it is important to note) - at second play wm8904_set_bias_level (..., SND_SOC_BIAS_STANDBY) is called. wm8904_hw_params is also called just before.
I see that all I2C transactions are good, registers are written as expected, especially volume control register (even the silly HPOUT_VU bit, to do a volume update is correctly written). Reading out this register, using i2cget (bypassing regcache), report the "expected" value. But the real output volume correspond to the default value (hw default, that it is the same value in wm8904_reg_defaults structure).
I checked that SYSCLK_ENA is 0 during register writing (needed if MCLK/SYSCLK is not present). I do not know if there is some other constrain on these registers.
If I rewrite the volume control register, a second time, the volume is set (tested with i2cset, from user space. And from kernel space, bypassing regcache).
I resolve also by reverting e9149b8c00d2 ("ASoC: wm8904: fix regcache handling"). I'm not here to say that the commit is wrong. I analyzed it and seem perfect (in few words it align the hw with the regcache avoiding potential incoherence).
I'm trying to compare first play and second play register programming sequence. They are similar but not the same. But on the first play the volume output is good.
Do someone remember something similar fixed on another codec? Any idea is appreciated. Thank you. Best regards,
Emanuele Ghidoli