On 01/07/2013 05:57 AM, Igor Grinberg wrote:
On 01/07/13 15:36, Mike Dunn wrote:
On 01/07/2013 01:16 AM, Igor Grinberg wrote:
On 01/06/13 21:13, Mike Dunn wrote:
[..]
static inline void pxa_ac97_cold_pxa27x(void) {
- unsigned int timeout;
- GCR &= GCR_COLD_RST; /* clear everything but nCRST */ GCR &= ~GCR_COLD_RST; /* then assert nCRST */
@@ -157,8 +159,10 @@ static inline void pxa_ac97_cold_pxa27x(void) clk_enable(ac97conf_clk); udelay(5); clk_disable(ac97conf_clk);
- GCR = GCR_COLD_RST;
- udelay(50);
- GCR = GCR_COLD_RST | GCR_WARM_RST;
- timeout = 100; /* wait for the codec-ready bit to be set */
- while (!((GSR | gsr_bits) & (GSR_PCR | GSR_SCR)) && timeout--)
mdelay(1);Can we use msleep() instead? May be this will require to change the granularity to 10...
Probably. mdelay() is used by similiar code in the same file, so I just stayed consistent. The code runs very infrequently, so I didn't worry about it.
Well, if we can, I think we'd better do, no?
If you feel strongly about it, I'll defer to you. But again my arguments are (1) the code runs very infrequently, and (2) very similar code for the other pxa family siblings uses mdelay().
Thanks, Mike