On Thu, May 02, 2019 at 02:10:39PM +0200, Fabien Parent wrote:
+static irqreturn_t mt8516_afe_irq_handler(int irq, void *dev_id) +{
- struct mtk_base_afe *afe = dev_id;
- unsigned int reg_value;
- unsigned int memif_status;
- int i, ret;
- ret = regmap_read(afe->regmap, AFE_IRQ_STATUS, ®_value);
- if (ret) {
reg_value = AFE_IRQ_STATUS_BITS;goto exit_irq;- }
...
+exit_irq:
- regmap_write(afe->regmap, AFE_IRQ_CLR, reg_value & AFE_IRQ_STATUS_BITS);
- return IRQ_HANDLED;
+}
This unconditionally says it handled an interrupt regardless of what happened. This means that the interrupt line can't be shared and that the error handling code in the generic interrupt subsystem can't tell if something goes wrong and the interrupt gets stuck.
- ret = devm_request_irq(afe->dev, irq_id, mt8516_afe_irq_handler,
0, "Afe_ISR_Handle", (void *)afe);- if (ret) {
dev_err(afe->dev, "could not request_irq\n");return ret;- }
Are you sure the interrupt handler can safely use managed resources, especially given...
- res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
- afe->base_addr = devm_ioremap_resource(&pdev->dev, res);
- if (IS_ERR(afe->base_addr))
return PTR_ERR(afe->base_addr);- afe->regmap = devm_regmap_init_mmio(&pdev->dev, afe->base_addr,
&mt8516_afe_regmap_config);- if (IS_ERR(afe->regmap))
return PTR_ERR(afe->regmap);
...that things like the register map and the I/O resources for the chip are allocated after and therefore freed before before the interrupt is freed. Normally the interrupt should be one of the last things to be allocated.
+static int mt8516_afe_pcm_dev_remove(struct platform_device *pdev) +{
- return 0;
+}
In general if functions can legitimately be empty they should just be omitted, if they are required that usually means they have to do something.