On Thu, Sep 20, 2012 at 05:28:55PM +0530, Ashish Chavan wrote:
- /* To select if MIC Bias powers MIC 1 or MIC 2 */
- SOC_ENUM("Mic Bias Select", da9055_mic_bias_select),
This would normally be something controlled by the board... what exactly is this doing? How does the MICBIAS relate to the microphone inputs?
Yes, it should be controlled by the board. This control selects which of the two MIC Bias pins acts as the BIAS source. Earlier we misinterpreted it because of a hardware modification which was present on the board without our knowledge.
OK, that sounds like it should either be hooked up in the DAPM graph or supplied as platform data then.
Given that there's no regulator support here it's also a bit surprising that you need to do a sync outside of system suspend...
I am not sure if I understood this fully. Do you mean a sync is not required here?
You only need to resync if the device might have lost power and forgotten it's register settings (or might've forgotten them for some other reason). If the device is left powered up then this isn't needed.