On 12/9/2021 2:10 AM, Mark Brown wrote:
Actually now I look again the only control interface this driver has is GPIOs but it does expose a digital interface with constraints as input so doesn't fit within simple-amplifier. However this is just powering off the amplifier to achieve mute rather than a separate mute control so it'd probably be better to use a SND_SOC_DAPM_PIN_SWITCH() for the Speaker widget to do this, this would also end up addressing Jaroslav's thing with the naming as a side effect. Sorry about the confusion there.
Thanks for suggestion. We tried using SND_SOC_DAPM_PIN_SWITCH() for the speaker widget and it invoke dapm_event callback based on switch i.e max98357a_sdmode_event() but codec driver isn't enabling/disabling gpios in such event callback instead they are doing that in dai_ops trigger callback. In our platform single I2S controller instance (cpu-dai) is connected to two different endpoints with a single PCM device, hence we want to switch or enable/disable output based on Machine driver controls only.
Initially we thought to configure gpio within sdmode_event callback but there was some pop noise issue reported in one platform with that change hence reverted. Check https://patchwork.kernel.org/project/alsa-devel/patch/20200721114232.2812254... So we thought of exposing a mixer control to enable/disable amp from UCM in our platform without breaking existing functionality. Please let us know any other alternative way if possible.