On 19.12.2017 18:00, Nicolin Chen wrote:
The trigger() calls fsl_ssi_tx_config() and fsl_ssi_rx_config(), and both of them jump to fsl_ssi_config(). And fsl_ssi_config() later calls another fsl_ssi_rxtx_config().
However, the whole routine, especially fsl_ssi_config() function, is too complicated because of the folowing reasons:
- It has to handle the concern of the opposite stream.
- It has to handle cases of offline configurations support.
- It has to handle enable and disable operations while they're mostly different.
Since the enable and disable routines have more differences than TX and RX rountines, this patch simplifies these helper functions with the following changes:
- Changing to two helper functions of enable and disable instead of TX and RX.
- Removing fsl_ssi_rxtx_config() by separately integrating it to two newly introduced enable & disable functions.
Signed-off-by: Nicolin Chen nicoleotsuka@gmail.com
sound/soc/fsl/fsl_ssi.c | 254 +++++++++++++++++++++++------------------------- 1 file changed, 119 insertions(+), 135 deletions(-)
diff --git a/sound/soc/fsl/fsl_ssi.c b/sound/soc/fsl/fsl_ssi.c index 0f09caf..d8c8656 100644 --- a/sound/soc/fsl/fsl_ssi.c +++ b/sound/soc/fsl/fsl_ssi.c @@ -378,31 +378,81 @@ static irqreturn_t fsl_ssi_isr(int irq, void *dev_id) }
/**
- Enable or disable all rx/tx config flags at once
- Set SCR, SIER, STCR and SRCR registers with cached values in regvals
- Notes:
- For offline_config SoCs, enable all necessary bits of both streams
- when 1st stream starts, even if the opposite stream will not start
*/
- It also clears FIFO before setting regvals; SOR is safe to set online
-static void fsl_ssi_rxtx_config(struct fsl_ssi *ssi, bool enable) +static void fsl_ssi_config_enable(struct fsl_ssi *ssi, bool tx) {
- struct regmap *regs = ssi->regs; struct fsl_ssi_regvals *vals = ssi->regvals;
- u32 sier, srcr, stcr;
- if (enable) {
regmap_update_bits(regs, REG_SSI_SIER,vals[RX].sier | vals[TX].sier,vals[RX].sier | vals[TX].sier);regmap_update_bits(regs, REG_SSI_SRCR,vals[RX].srcr | vals[TX].srcr,vals[RX].srcr | vals[TX].srcr);regmap_update_bits(regs, REG_SSI_STCR,vals[RX].stcr | vals[TX].stcr,vals[RX].stcr | vals[TX].stcr);
- /* Clear dirty data in the FIFO; It also prevents channel slipping */
- regmap_update_bits(ssi->regs, REG_SSI_SOR,
SSI_SOR_xX_CLR(tx), SSI_SOR_xX_CLR(tx));- /*
* On offline_config SoCs, SxCR and SIER are already configured when* the previous stream started. So skip all SxCR and SIER settings* to prevent online reconfigurations, then jump to set SCR directly*/- if (ssi->soc->offline_config && ssi->streams)
goto enable_scr;- if (ssi->soc->offline_config) {
/** Online reconfiguration not supported, so enable all bits for* both streams at once to avoid necessity of reconfigurations*/srcr = vals[RX].srcr | vals[TX].srcr;stcr = vals[RX].stcr | vals[TX].stcr;sier = vals[RX].sier | vals[TX].sier;
regmap_update_bits(regs, REG_SSI_SRCR,vals[RX].srcr | vals[TX].srcr, 0);regmap_update_bits(regs, REG_SSI_STCR,vals[RX].stcr | vals[TX].stcr, 0);regmap_update_bits(regs, REG_SSI_SIER,vals[RX].sier | vals[TX].sier, 0);
/* Otherwise, only set bits for the current stream */srcr = vals[tx].srcr;stcr = vals[tx].stcr;sier = vals[tx].sier;
Implicit assumption here that RX == 0, TX == 1, as in the 03 patch.
}
- /* Configure SRCR, STCR and SIER at once */
- regmap_update_bits(ssi->regs, REG_SSI_SRCR, srcr, srcr);
- regmap_update_bits(ssi->regs, REG_SSI_STCR, stcr, stcr);
- regmap_update_bits(ssi->regs, REG_SSI_SIER, sier, sier);
+enable_scr:
- /*
* Start DMA before setting TE to avoid FIFO underrun* which may cause a channel slip or a channel swap** TODO: FIQ cases might also need this upon testing*/- if (ssi->use_dma && tx) {
int try = 100;u32 sfcsr;/* Enable SSI first to send TX DMA request */regmap_update_bits(ssi->regs, REG_SSI_SCR,SSI_SCR_SSIEN, SSI_SCR_SSIEN);/* Busy wait until TX FIFO not empty -- DMA working */do {regmap_read(ssi->regs, REG_SSI_SFCSR, &sfcsr);if (SSI_SFCSR_TFCNT0(sfcsr))break;} while (--try);/* FIFO still empty -- something might be wrong */if (!SSI_SFCSR_TFCNT0(sfcsr))dev_warn(ssi->dev, "Timeout waiting TX FIFO filling\n");- }
- /* Enable all remaining bits in SCR */
- regmap_update_bits(ssi->regs, REG_SSI_SCR, vals[tx].scr, vals[tx].scr);
Ditto.
- /* Log the enabled stream to the mask */
- ssi->streams |= BIT(tx);
Ditto.
}
/** @@ -426,65 +476,50 @@ static void fsl_ssi_rxtx_config(struct fsl_ssi *ssi, bool enable) ((vals) & _ssi_xor_shared_bits(vals, avals, aactive))
/**
- Enable or disable SSI configuration.
- Unset SCR, SIER, STCR and SRCR registers with cached values in regvals
- Notes:
- For offline_config SoCs, to avoid online reconfigurations, disable all
- bits of both streams at once when the last stream is abort to end
*/
- It also clears FIFO after unsetting regvals; SOR is safe to set online
-static void fsl_ssi_config(struct fsl_ssi *ssi, bool enable,
struct fsl_ssi_regvals *vals)+static void fsl_ssi_config_disable(struct fsl_ssi *ssi, bool tx) {
- bool tx = &ssi->regvals[TX] == vals;
- struct regmap *regs = ssi->regs;
- struct fsl_ssi_regvals *avals;
- struct fsl_ssi_regvals *avals, *vals = &ssi->regvals[tx];
Ditto.
u32 sier, srcr, stcr, scr; bool aactive;
/* Check if the opposite stream is active */ aactive = ssi->streams & BIT(!tx);
- /* Get the opposite direction to keep its values untouched */
- if (&ssi->regvals[RX] == vals)
avals = &ssi->regvals[TX];- else
avals = &ssi->regvals[RX];- if (!enable) {
/** To keep the other stream safe, exclude shared bits between* both streams, and get safe bits to disable current stream*/u32 scr = ssi_excl_shared_bits(vals->scr, avals->scr, aactive);/* Safely disable SCR register for the stream */regmap_update_bits(regs, REG_SSI_SCR, scr, 0);/* Log the disabled stream to the mask */ssi->streams &= ~BIT(tx);- }
- /* Get regvals of the opposite stream to keep opposite stream safe */
- avals = &ssi->regvals[!tx];
Ditto.
/*
* For cases where online configuration is not supported,* 1) Enable all necessary bits of both streams when 1st stream starts* even if the opposite stream will not start* 2) Disable all remaining bits of both streams when last stream ends
* To keep the other stream safe, exclude shared bits between* both streams, and get safe bits to disable current stream
- if (ssi->soc->offline_config) {
if ((enable && !ssi->streams) || (!enable && !aactive))fsl_ssi_rxtx_config(ssi, enable);
- scr = ssi_excl_shared_bits(vals->scr, avals->scr, aactive);
goto config_done;- }
- /* Disable safe bits of SCR register for the current stream */
- regmap_update_bits(ssi->regs, REG_SSI_SCR, scr, 0);
- /* Online configure single direction while SSI is running */
- if (enable) {
/* Clear FIFO to prevent dirty data or channel slipping */regmap_update_bits(ssi->regs, REG_SSI_SOR,SSI_SOR_xX_CLR(tx), SSI_SOR_xX_CLR(tx));
- /* Log the disabled stream to the mask */
- ssi->streams &= ~BIT(tx);
Ditto.
Maciej