On 07/10/2015 11:50 PM, Anatol Pomozov wrote:
Hi
I have following hardware configuration
[SoC] <=> [RT5677] <=> [MAX98357A]
MAX98357A is a simple speaker amplifier with I2S data interface and no I2C control. The chip automatically configures itself (rate/block frequency) when I2S is started streaming to the chip. This chip does not need a driver (there is nothing to configure) and we can use "dummy-codec" for it.
The dummy CODEC is only meant to be used in situations where there is no actual hardware.
If there is actual hardware even if it does not have a control bus the hardware will still have constraints like supported samplerates, etc. which should be modeled. And the data flow graph also should be modeled using DAPM.
There is a DAI link between RT5677 and MAX and it should be configured from RT5677 side. RT5677 is master here and it need to set I2S bus parameters. Configuration happens in rt5677 hw_params() function and it is triggered by dai link activation.
My question is how to tell DAPM that I need to activate this link?
If MAX98357A was a real codec then it would have an OUTPUT widget that I can activate, this would trigger dai link in between to be activated as well. But dummy codec does not have any widgets, so how I suppose to activate link to dummy codec?
You just gave the answer yourself, make it a real CODEC :)
- Lars