Hi Mark,
On Mon, Oct 05, 2015 at 10:44:35AM +0100, Mark Brown wrote:
On Sun, Oct 04, 2015 at 03:38:16PM +0200, Maxime Ripard wrote:
Most of the boards have their headphone jack directly connected to the matching pins of the SoCs. Since most of the time we will have the same routing path, it makes sense to put that in the driver, and only have a property describing whether that route is enabled or not.
What is the value in having just a dumb jack with no detection configured? It doesn't actually do anything...
Well, it's how it's wired on most boards. The jack is directly connected to the SoC, without any detection mechanism, not even a GPIO, so we can only assume it's always there if we want it to work properly.
It also fixes the following warning messages that were seen so far: sun4i-codec 1c22c00.codec: ASoC: no sink widget found for Headphone Jack sun4i-codec 1c22c00.codec: ASoC: Failed to add route HP Left -> direct -> Headphone Jack sun4i-codec 1c22c00.codec: ASoC: no sink widget found for Headphone Jack sun4i-codec 1c22c00.codec: ASoC: Failed to add route HP Right -> direct -> Headphone Jack
Why are these routes being added separately to adding the jack? Just remove the broken routes.
I'm not sure I understand here. The former DT bindings example was adding this route, which was broken because of the missing output widget for the headphone jack.
My patch here adds both if the DT says that the headphone jack is actually used on that board, so it should fix both issues: no broken route, and no missing widgets. right?
Maxime